Awesome, thanks. Scarab, I am pretty sure the it will work for the Blazers too.
Printable View
Awesome, thanks. Scarab, I am pretty sure the it will work for the Blazers too.
Yes, finally. :bash:Quote:
Originally Posted by ScarabEpic22
Quote:
Originally Posted by Blacky
YES!!!!
Finally, this is going to make it a breeze for me to swap to a set of 20s here in the spring when I buy them!!
Thank You!!Quote:
Originally Posted by Blacky
Will you post the link here when the update is ready? Will we only have to update the EFILive software? I just want to make sure I'm ready to start using it the day it comes out.
???
Nearly done - just adding support for a few weird anomolies with the way some PCMs calculate speed.
Who knew GM had sooooo many different ways to determine the speeds of the varous drive shafts, axles, diffs, chains, sprockets, gears and tires.
Regards
Paul
We really appreciate yor work, can't wait to try it!
I recently shortened my driveshaft, is there a correction factor in the LLY ECM to change? ;)Quote:
Originally Posted by Blacky
Just tried the new calculator....very nice!
BUT when entering values by hand (not picking from the list) the circumference does not update.
In my case I needed to enter 325 for width which is not available in the drop down menu. The update button to the right is grayed out also.....You might want to expand the table to 365 as these are widths found on HD trucks!
Update: This issue seems to be intermittent as it does work sometimes....