-
torque managment
Hello can someone point me in the right direction for torque management cm2350 ? working with file DO90008.08. The truck runs better with some adjustments but still cant even spin the tires. I'm not looking to brake the truck in half but a little giddy up below 1600rpm would be nice. I tried disabling limiters in D2019 and then I tried increasing rpm in all tables in rpm limiter torque adjust. Im not able to log data with efi so on my scanner when I try a boosted launch it will command around 350lb tq and mode switches to other and it flattens out. Can someone lend me a hand? regards 26sutphen....
-
Deleted or emissions equipped tuning?
-
everything is still in place. Thank you for the prompt reply
-
Have you modified the Trans parameters to remove torque management?
-
I have not, I looked through the parameters but didn't see anything for torque management.
-
There are some in there, and are you turning off your traction control on the dash?
-
can you point me to the limiters for the trans? and I haven't disabled the traction control. Duh on my part. but the tires don't even slip and activate it. Also when driving and doing a roll on its just real soft down low.
-
You need to actually add power down low along with raising limiters and traction control deactivation. Pedal table, torque to fuel tables, pulse table etc
Just turning or raising torque values without adding power won't spin the tires.
-
You do need to be careful with how much torque you add...the emissions system will begin to get irritated and will give you issues if you push too hard down low.
Do you have a way to monitor dpf pressure delta and if it's regenerating or not?
-
Ok, Kinda what I did. On the pedal map I requested more torque. Then I went to torque limiters and made sure what I requested was was that or greater. Then I looked at the torque to fuel and made sure at a given torque the fuel was atleast that or more in the main limiters. it seems to have woken the truck up but still nothing down low...I know im missing something that's why im asking for some help. and thank you for the replies