Any thoughts when the next update might be? I was hoping to be able to log both ECM & TCM on thursday at the pull. If it'll be out by then it would be great, but if not, I can survive with just ECM data.
I'm trying to get it out tonight (as a pre-release).
Regards
Paul
July 24th, 2011
GMPX
Quote:
Originally Posted by Cougar281
I've viewed both IAT and IAT2 with my Tech2.
Have you tried SAE.IAT & SAE.AAT?
I suspect that SAE.IAT will be the temp sensor in the MAF and SAE.AAT will be the one on the intake pipe.
July 24th, 2011
Cougar281
Quote:
Originally Posted by GMPX
Have you tried SAE.IAT & SAE.AAT?
I suspect that SAE.IAT will be the temp sensor in the MAF and SAE.AAT will be the one on the intake pipe.
I'm pretty sure I have, but I'll double check again tomorrow afternoon.
July 25th, 2011
Cougar281
Quote:
Originally Posted by GMPX
Have you tried SAE.IAT & SAE.AAT?
I suspect that SAE.IAT will be the temp sensor in the MAF and SAE.AAT will be the one on the intake pipe.
Nope. I don't know where the AAT pid is coming from, but it's not the sensor in the MAF. When I unplugged the MAF, it's value was unchanged. Whe I was scanning the ECM with the Tech2 and unplugged the MAF, IAT dropped to -40 (open circuit).
July 25th, 2011
Blacky
Quote:
Originally Posted by Blacky
I'm trying to get it out tonight (as a pre-release).
Regards
Paul
Couple of small delays. Update will probably be available in about 24 hours.
Regards
Paul
July 25th, 2011
GMPX
Quote:
Originally Posted by Cougar281
Nope. I don't know where the AAT pid is coming from, but it's not the sensor in the MAF. When I unplugged the MAF, it's value was unchanged. Whe I was scanning the ECM with the Tech2 and unplugged the MAF, IAT dropped to -40 (open circuit).
I'll have to get our Candi module off the person I loaned it to and see what is going on with the PID's shown on the TechII.