-
1 Attachment(s)
V2 died?
Out of nowhere I went to use my V2 to pull some codes out of my truck and all I got was this. Tried a different vehicle as a test and same thing. Three LEDs lit continuously and screen is blank. Doesn't matter if I power up via laptop or by an OBDII port I see the same result. Removed/reinstalled SD card several times with no change. Is it dead? Not sure what to do.
-
If you have checked OBD power (without USB connected) and you get the same result you could try booting FlashScan in one of the special power up modes listed here https://service.efilive.com/kb/artic...power-up-modes
Cheers
Cindy
-
Thanks Cindy.
I just tried all three boot up methods, powering up via USB then OBD individually and only see the same results as before. Nothing but the three leds.
-
I am having the same issues, It happened after I used a bench harness to flash an E38, it is a harness I have used dozens of times before.
I tried the boot methods mentioned above and no go, the computer does see the V2 but it doesn't respond. Codes are as per blinking lights: $0081 and $0082.
Is this repairable?
Thanks
-
I don't even get any blinking lights, they're all just illuminated steady as seen in the pic. When connected via USB all I get is a "device not recognized" notification. No screen or anything on the V2.
-
Can you please create a ticket on our help desk for support to look at your issue? https://service.efilive.com/new-ticket
Thanks
Cindy