Printable View
Currently working on an 05 SSR LS2 Truck and trying to log as always typical pids in the e40 ecu. Nothing othert than temps, (ect iat) and rpm signal available. All other external pids are also available. Can someone help me with this issue? I just hooked up same laptop and software to an 05 Vette and all pids are present. Not sure where to go from here. Thanks
Chris Lovett
Wichita Dyno
chris@wichitadyno.com
Just jumping on here and read this. Someone knows the answer. Good luck cause that seems odd. Quick fix I hope
Is the VIN set correctly in the ECM?
I was in process of checking that this morning. I will post what I find.
Hit the Green Check mark to verify all pids and now everything is fine. I dont understand how it will scan fine on one ecu but not the other. Thanks
You need to validate the PIDs on each controller when you connect to it for the first time.