Cant see cax transient fueling

Hi,
hope someone can help.
installed new injectors fic 60lb and corrected data in tune.
ran it up and running very rich on no load.at 12 afr at idle.

Read here and efilive forum may need cax files to get table b9021.?
downloaded and copied cax file for my operating system on my LS1B to correct place in laptop.
have reopened file hoping to see b9021, still not there...
went into properties in efilive and ticked two boxes to allow cax files.
still no b9021 table not found. Have seen transient fueling new tab but no b9021
When it loads up with cax file in correct place it brings up message but no mention of above
Any ideas?
banging head against brick wall.
regards
gavin

Ok was using wrong cax, have now seen b9021 and set same as b4003 and b4004 at 0.125. Will see how it goes now...

Link for cax was https://forum.efilive.com/showthread...01250003/page2
Regards
Gav

Hi Gav,

Glad you got it sorted out.

Which OS do yoi have?

Hi Joe,
COS3 , needed cax file b from above link, not tried it yet though, have set b9021 to 0.125 same as other tables. Hoping it will fix rich idle...
Regards
Gav