In the map properties, on the Rows tab, select MAFFREQ or MAFFREQ2 rather than MAF...
this implies that you have to log MAFFREQ or MAFFREQ2, whichever one works on your ECM.
Printable View
In the map properties, on the Rows tab, select MAFFREQ or MAFFREQ2 rather than MAF...
this implies that you have to log MAFFREQ or MAFFREQ2, whichever one works on your ECM.
Also (not related):
- if you have drive-by-wire then log GM.ETCTP rather than GM.TP.
- drop the pid GM.EQIVRATIO since it does not work.
- the pid SAE.LAMBDA is producing EQR (i.e. it's doing what GM.EQIVRATIO should have done)... so we'll have to factor this in to the BEN pid (when you use a wideband).
Ok, got the pids working and going to go log here shortly.
I got something to populate.
Attachment 21243
Hope that's what I was needing to get done.
In the map properties, goto the Cell tab and constrain the cell size.
~ posted by phone ~
And on the map toolbar click x-bar.
~ posted by phone ~
Post log file.
~ posted by phone ~
Attachment 21246 Here is the screen shot.
Attachment 21247
Attachment 21248 Tune and Log file.