Printable View
I have it all hooked up and calibrated.
My question is... in my EFILIVE software, what do I activate and where do I find it. My EFILIVE instruction book is way to vague.
I have tried to use and can not get it to read on my EFILIVE. I have changed some settings, but it is not working.
Please help.
The instruction manual was pretty straight forward for me
and this post was stickied right above your post. Easy to follow directions
http://www.efilive.com/forum/viewtopic.php?t=1145
Most of your questions have been answered at least 3 times on the board use the search feature and i am pretty sure it will steer you in the right direction..
The LC-1 is now pre-configured in EFILive (V7.3) so you don't need to set up your own calculated PIDs.
Select and log the following PIDs:
{EXT.AD1} or {EXT.AD2}
{CALC.AFR_LC11} or {CALC.AFR_LC12}
{CALC.BEN_LC11} or {CALC.BEN_LC12}
Whether you choose "1" or "2" as the last digit in the above PIDs is determined by which pin you connected your LC-1 "Analog 2" wire to on FlashScan.
If you connected the LC-1 "Analaog 2" wire to FlashSCan pin "E", then use "1", if you connected the LC-1 "Analaog 2" wire to FlashSCan pin "C", then use "2".
Make sure you connect the Analog ground to PIN "D" on FlashScan.
Regards
Paul