Modifying cal file for 10mm CP3 on LML

Hey Guys-

I'm installing an S&S 10mm CP3 on my truck (LBZ based) pump. I want to modify my cal file so I can drive it and make sure everything is ok before I get it tuned. Did some searches and it looks like I need to modify "Desired flow VS Current" table for the Fuel Pressure. Anyone have any additional guidance? Is there anything else I need to pay attention to?

Quote:

---

Originally Posted by Dustin_360

Hey Guys-

I'm installing an S&S 10mm CP3 on my truck (LBZ based) pump. I want to modify my cal file so I can drive it and make sure everything is ok before I get it tuned. Did some searches and it looks like I need to modify "Desired flow VS Current" table for the Fuel Pressure. Anyone have any additional guidance? Is there anything else I need to pay attention to?

---

Attached is a good baseline to start at that fleece posts with thier conversion kits.

https://www.fleeceperformance.com/me...Un_Scaling.pdf