FlashScan to LC-1 Serial Cable Diagram

Diagram showing the various cables and pin-outs required to connect FlashScan to an Innovate LC-1 or LM-1 Wide band controller.

For those that want a simple cable solution, you can wire up an RJ12 plug directly to the 3 pin jack as follows:

Code:

---

RJ12    Jack
------ ------
 1 <---> 1 (tip)
 2 <---> 2 (middle)
 5 <---> 3 (base)

---

Regards
Paul

The null modem connector can be purchased here:
http://www.sfcable.com/cable/p/30D1-C1-S.html

If you want to make your own male-male null modem cable, see images below.
(Ok, so the soldering could be better, I'm just a programmer. Beware the programmer wielding a soldering iron...)

Regards
Paul

For those of you that can't locate your LC-1, LM-1 and/or FlashScan serial cables, this is what they look like.

Regards
Paul

The names of the pins are as shown in the 3rd column:

Quote:

---

Originally Posted by Blacky

Code:

---

  RJ12        Jack        Name
------    ------------  -----------
  1  <--->  1 (tip)      Tx Data
  2  <--->  2 (middle)    Rx Data
  5  <--->  3 (base)      Ground


---

---

Innovate LC-1 and LM-1.

Also see here: showthread.php?t=9340