Dsp5 not switching tunes

my dsp5 is not switching tunes i checked can rechecked to make sure that the wires where in the right holes. I have taken a meter to them and got resistance and the resistance would chang when swithing the switch. On my lap top i have tryed to log data from the dsp voltage and it wont log anything saying that one that one pid has been selected and i checked to see if anything else was selected and nothing was and it also said to change the scanning speed. Only one of the tunes was able to be loaded to the truck.. Anyone got any ideas why the other tunes are not loading or what could be wrong

Did you do a full flash, or a cali flash?

Full flash is what i did

can you data log either dsp5 voltage ( lb7-lly or lbz) and dsp5 tune#
also check in you tune where the volages are set for each tune. i got caught with this they were all set at 0 voltage

when i try to log data it says more than one pid has been selected when i have only clicked on one and then tryed to change the settings that it says to have on the pop up error and retry it and it just says the same thing

post a screen shot

Where did you get your switch? What kind of vehicle are you attempting to flash?

Cheers
Cindy

I got the switch from diesel addiction and it's for a 2005 duramax lly

Time to post a screen shot.

Cheers
Cindy