-
OS3 installed
I have done autoVE over the past few days and got it to a stage where i could upgrade my program to the new OS3 and setup all the other tables.
It all worked fine. I now have a duel spark table, lean cruise enabled, PE at 95% and stoic to 75MAP then blending to similar to PE. I may as well turn PE off.
I have even enabled IAT correction from data i collected while building the new VE table and i have it at about 1% correction every 10 deg.
At the moment i have my desired spark table 3 deg above the lower one. I will trim them both together for a while keeping a 3 deg gap and then aim to pump up the hioctane table in cooler conditions.
How do i set the amount of knock needed to learn either way with the spark tables. I would also like to plan how i can setup a table for ethanol fuel as well.
Having some trouble with surging - have played a little with the timing correction of hi and low idle. But i think the issue is with idle air or something else.
My VE table is not ideal near 400-800 i wish there was a 600 row as well !
Great work Blacky and GMPX its a sweet and powerful package you have created. :thankyou2:
-
What size injectors are you running that you don't have ideal VE in the 400/800 rows?
Are you constantly getting autoVE of like high 70's low 80's BEN?
That is what I am seeing on the cars I have done with 60lb injectors.
-
I just made the 400rpm and 800rpm cells much more similar hoping this may help some idle issues. I have 36lb injectors.
-
Flyer - are these the 36 lb GTP (white) injectors?? If they are I have Injector Offset and Pulsewidth Tables from an ASA tune (58 psi fuel pressure) - if you want them.
What are you tuning?? Mods??
FWIW.
:cheers:
joel
-
They are the common SVO30 injectors. But thanks anyway.
The car is a VX Clubsport 216 220 Cam 114LSA 1.8 rockers
SS3600 Qtecs Ported TB (like a S3) 3.73 25% UDP
Ported Heads at 10.7:1
Its run 11.765/115 1.622 on MT ET street Radials.
This was pre-heads.