Printable View
Ok, I must have screwed up something. Why is it that I cannot paste this into my b0101? It completely destroys the graph when I do this...I have tried paste with labels, paste and multiply also, and just paste. SELBEN i pasted with labels and multiply and the graph barely moved. Just needs a small amount of smoothing.
Post a screenshot of your map (make sure it shows cell/axis units)...
Here they are, SELBEN is long so i tried to put it on 2
The g*K/kPa map (image 1, VET.png) should pasted into B0101 (if B0101 has units g*K/kPa).
The other images show CYLAIR rather than SELBEN... if you have the SELBEN map then it should paste-multiply into B5001.
edit: my mistake, I did not pay attention (the map title says SELBEN, the column title says CYLAIR_DMA)
Note: in both cases use the "with labels" form of the paste (i.e. paste-with-labels into B0101, and paste-multiply-with-labels into B5001).
Post a before/after pic of your B0101...
Here is b0101 and b5001 before and after
I think I am confused as I thought I was logging SELBEN, is this not the one to get paste/multiply into 5001?
Maybe this one is easier to read...I like the graph for adjusting things.
Sorry to blow this up with pictures, but at least ill have them available for you!!! Is this too much editing? Should I add things in those low areas?? or make the peaks lower?
The pic of the MAF map in post #123 showed CYLAIR_DMA (look at the map's title bar) rather than SELBEN...Quote:
Originally Posted by Nver2loud
edit: my mistake, I did not pay attention (the map title says SELBEN, the column title says CYLAIR_DMA)
just make sure you're paste=multiplying SELBEN into B5001...
for the MAF map, go into map properties, goto Data tab, and select CALC.SELBEN, checkmark show units, then save the properties.