Search:

I just wanted to report back the results. The modifications that you made worked just fine. The engine runs up to the appropriate rev limiter and performs very well for a stock tune. Now i can...

Sorry , i can note load this file ; it comes back as can note use this version calibration with this software. I am using a v-2 flash scan and all my software and firm ware are up to current date, i...

Thanks i will load it in and report back thank you

No code pressent

Here is the file

I am using a 0-5 volt reference ; as for the support as of yesterday they said no on this operating system

I contacted hp tuners and they said that they did not support this operating system, perhaps i need to contact them again. I attempted to simulate the clutch pedal input however i can not get the...

No i am using a 6 speed manual transmission base calibration

The calibration is for a six speed manual transmission, the sand rail uses a volkswagen trans axle. I am not currently supplying any speed signal to the controller

I'm running a 2012 Chevy Cruze 1.4 turbocharged EcoTech in a sand rail. I'm using an E78 controller with the 2012 OEM calibration. Operating system number 12646746. I can't get the engine to rev past...

Dose smeone have a current base calibration from gm for the ls-3 480 hp crate engine ?

I am running a 2.4 ecotec with a e37 as a stand alone system i am running a 2008 hhr manual transmission base calibration with a vat patch other than that it is basically unchanged according to the...

Can anyone offer me help regarding the following matter. I have a gm ls-3 - 480 hp crate engine with an e-38 controller. The base calibration is from howell engine development and it is a 2007 ...

I am looking fo a base calibration for a ls-3 480 hp crate engine with a e-38 controller can any one help.


Thanks, steve sbelgio

...