24594
Hi I have attached the tune file. The engine is out of a box truck & is currently governed to 70MPH. I have maxed out H0111, H0109 and H0108. What am I missing here? Any help would be...
Type: Posts; User: BustedTruck; Keyword(s):
24594
Hi I have attached the tune file. The engine is out of a box truck & is currently governed to 70MPH. I have maxed out H0111, H0109 and H0108. What am I missing here? Any help would be...
So basically find the pedal i want to run? I've read that the e67 is easier for cruise to be added?
So I've built a L92 out of a yukon denali. It came to me as a core, so I have no harness or ECM yet. Its going in to a 71 C10. The only mods to the engine is the ASA camshaft & remove VVT. The trans...
I'm gonna beat a dead horse. Could I remove the theft on a e69 ECM for transplant. I understand it's not supported for tuning, but if I just wanted to remove the theft so I can start the car, is that...
Thanks, that took care of the problem. Thank you for the quick resolution.
Thanks for the quick reply.
software 7.5.6 Build 133
Firmware Version 2.07.22 Date Aug 23 2011
Ok when I hook up my V2 I can go through its menu & it shows to have 1 liscense available. When I bring it up in the tune software none of the vins show up. I went ahead & purchased two additional...
Yeah checking on the road with a gps. The software said it wrote successfully, but the changes are not reflected.
I am trying to adjust the speedometer for different tires. No changes that I make are reflected on the speedometer. What am I not doing here. I am working on a 2010 corvette zr1. Any help would be...
Ok, I got it. I tried downloading the file like 6 times. Tonight it worked. Thanks for all the help
Ok, my old laptop crashed. I purchased a new laptop with windows 7 professional 32-bit When I try to install the version 7.5 I get an error message. "bad CRC this indicates that your setup file might...
I am working on a 2005 tahoe drivetrain. I was able to view oil pressure sensor voltageEngine Oil Pressure Sensor Voltage . If you select both pids at the same time the calculated oil pressure...
Ok I have renamed the file to calc_pid.txt. when I click on the pid its not valid. Any idea what I am doing wrong? Thanks for being patient.
OK I've got those selected, now what?
Ok I have done that, but I still do not see the PID listed. What am I doing wrong?
I am having the same problem. I am a total newb just trying to learn. What do I do with the attatched file?
Thanks. Wow very informative. Thanks for the information.
That was some good reading. I have lowered mine to .1 and I like it. My concern was some type of gear overlap when the shift times were at 0, but there seems to be alot of people setting theirs to 0....
Thanks for the reply. Efi does not specify not to go below .1. How long have you had yours set a 0, Scarab. Have you noticed any ill effects? I am installing the corvette servo this week. Does...
I read somewhere on this forum that you do not want to go faster on your shift speed than .1 seconds because of gear overlap. Is there any truth to that? I have heared of people zeroing this value....