Well...i finally got it working!
I just modified my Autocal to work with a serial wideband so you can read wideband/AFR and datalog for your tuner to get better information.
This WILL void...
Type: Posts; User: derek1387; Keyword(s):
Well...i finally got it working!
I just modified my Autocal to work with a serial wideband so you can read wideband/AFR and datalog for your tuner to get better information.
This WILL void...
Got everything hooked up from the Innovate LC2 to my Autocal, wired to the RX/Ground...not receiving any data. Is there anything special in EFILive i need to add other than the Serial WB PIDs?
We have a flex fuel sensor wired in right now and are reading that through the autocal-and we had to enable pin 38 on the ECM. So, i see what you mean now. Ill link my tuner to this thread and let...
Ahh OK. But, only if its serial. Not analog data. Correct?
Alright, such as the AEM or possibly an Innovate? Then just wire in the RX/TX/Ground to the Autocal with a connector, and match it on the wideband controller?
Im sorry...i may just be dense...AC instead of FS? I am new to the whole tuning process...still learning.
Any more information on this? I am looking at a PLX wide band and not seeing on the PLX how it would connect to a serial connector.....unless im just not looking at the right thing.
There has to be a way to use this analog wideband ....
Talked with my tuner, Overkill, he siad there isnt an EGR pintle available to do that (no EGR on the car).
Attached is the pin-out for...
I have it modified right now to accept a serial connection. Just not sure what connector to put on the end...
http://i83.photobucket.com/albums/j286/Derek1387/IMG_1644_zpsfzmzjedq.jpg
I am...
ill check. 2015 V6 Camaro LFX engine. I dont believe so
Any recommendations then for me folks?
Looks like i can use a serial one by doing this: https://forum.efilive.com/showthread.php?26113-Autocal-and-external-wideband-using-serial-comms&p=224316&viewfull=1#post224316
But looks like the...
Ahh, my bad. Its not serial. Its analog.
So is there anything I would need to do/custom PID and setup on the Autocal for that to work?
I have setup/modified my Autocal to read with a wideband thanks to the thread i found on here.
I have a Ballenger Motorsports AFR500, which is essentially the NGK AFX, with the NTK sensor. Which...
Yessir, sorry for the delay. Apparently my car can be read on E39A, but scanned/flashed on E39. It only had E39A setup.
Up and running just fine now. Now to setup the wideband!
I have reloaded the config files per my tuner. Still same issue
How do I verify if it's setup properly?
2015 Camaro V6 LFX. Has the e39a ECM from what I understand.
I'm honestly not 100% sure. Just got the Autocal and trying to figure things out
I will be posting the Options.txt when I get to a...
Just received my Autocal from my tuner-was able to flash the tune on just fine. But when I try to Record Data, it does not create a log file. It goes to ECM AIRFUEL, then right back to Record Data,...