sorry for the late reply, the issue was a restricted fuel line. Repaired that and the tune came in near perfect.
Thanks for the help!
Type: Posts; User: mecnic99; Keyword(s):
sorry for the late reply, the issue was a restricted fuel line. Repaired that and the tune came in near perfect.
Thanks for the help!
Yes
No I'm not sure it's running on the v.e only. I have maf signal disconnected p0101 no error, p0102 no mil and p0103 no mil, and fail frequency set to 150 so it should be v.e. only. Yes the o2s switch...
So I have this all set up, now it leans out my stft to the point it will barely run. My o2 show 800-1000mv which should be rich and the reason it keeps subtracting from my v.e.table. I have it set...
i know this is an old thread, but has anyone tried to use a road runner on v8? i have yet to figure out how to put in my key to activate it, i show the cummins and tune upgrade but not the road...
I made the changes that Joecar mentioned and the problem is still there, I installed a different tune from a nearly identical setup and the lean condition is still there. At this point, I think the...
no it is s/d and I won't be able to log it again until the weekend.
can't believe I didn't see this.
sorry for the delay but here is the tune file.
This is a 5.3 with a asa 525 cam. the issue is a constant lean condition under a wot snap from idle. I have added up to 30% more fuel in the v.e. table and it has had no effect. this a s.d.tune. if...
hey joe, i was looking and reading the user note in A0011 and it reads that this is used on (j2,pin56) shouldn't it be C2,pin 56?
I fixed all oor cells along with B3647, hopefully when it warms...
cos is now loaded and cal is flash in. read the file and the cos is there. adjusted what I needed and now ready to tune.
ok so running as administrator is the fix. i wasn't getting the 3-4min programming process of the flash before and it works fine now. still shows flash fails but it's after the reprogramming phase of...
16619 i'm also getting this error also.
I think i have something different going on that what #11 is refering too.
1661716618
this what i get everytime i try to full flash the cos02020003
under stand that much. but is won't complete the full flash of the cos..
screen shot how too??
that's was what i had done.
tried again tonight.
i started from the 12212156 cal full flashed(not problems) then full flashed 02020003 and the flash gets almost the end and fails. if any of my...
12212156 os and tried using (trying to recall but I think it is) cos 02020003 and 05. I am running v7.5.7 software.. I found the cos in the tutorial that corresponds with my os. not sure what is...
i performed a full flash and it failed. then i flashed stock cal. and read it out of curosity and it shows ve to be in psi and rpm. this what i would expect accoring to all i have read. is this...
thank you Taz. new to this software and i seem to get lost in the forums.
I'm trying to build a cos for a boosted 6.0. I have read the file and I don't have an option for a cos. do I have to perform a full flash before this will become available. I'm using a operating...