Update.. Turns out there was a misunderstanding between myself and the tuner regarding the amount of work I was doing.
The tune was configured for a 1 bar MAP sensor but I left the 2 bar MAP in...
Type: Posts; User: Johnnydangerously; Keyword(s):
Update.. Turns out there was a misunderstanding between myself and the tuner regarding the amount of work I was doing.
The tune was configured for a 1 bar MAP sensor but I left the 2 bar MAP in...
Assuming the tune is fine, what would be the process of tracking down the problem?
My tuner shot me an email and said VATS wasn't off.
I uploaded the new tune that turned off VATS but the car is still dying after about 5 seconds. Runs fine then bogs down and keput.
Hi Taz, thanks for the response and explanation of the SD tune parameters.
I have a V2..
The owner of the shop has been in touch with me, we are just waiting for the man with the laptop to...
not sure what was done, I don't really play around with their tunes.
2004 Z06
I emailed my tuner and they sent me a tune for the new setup. After the full reflash, I turned the key to the run position a few times to build up fuel pressure. I tried starting the...
Im looking to add two points to log oil pressure on my car (for the turbos)... Anyone know who makes oil pressure sending units with a 0-5vdc signal?
Thanks guys.. All squared away.. :rockon: :rockon:
I had a feeling that was the case.. Thank you for the info..
I have an SD tune, MAF is not installed or hooked up and the P0102 "Mass Air Flow (MAF) Sensor Circuit Low" code is getting thrown.. I tried to set this code from C: Non Emissions, to Not reported,...
Thanks Joe..
Hey Joe, Im located in NY... Ive been doing some research on the reason I failed and here is what I found.. Test so it looks like I have to set my MILs back to stock (if they aren't already).. ...
Car DOES NOT get hooked up to a sniffer.. All they do is hookup to the ECU and check the readiness and DTCs..
Car is a 2004 Z06 with twin turbos, cam, 60lb injectors, no cats, and an SD tune, the maf is not hooked up.
The car failed emissions for the following:
OBD Monitor Readiness Status
- Catalyst: ...
i checked the size of the SD cards and they're the same.. went to go logging and sure enough it lost connection, got home and there was about 1 second of data.. :doh2: im gonna start using the...
Just bought the tune/scan software and started logging however there are times when the hand held unit says the SD card is not present.. I tried two other cards that that seem to be better (they...