Ok awesome! Thank you very much.
1. So when I am logging with my pc connected all I need to do is select the pids "CALC.AFR_NGK1 and CALC.AFR_NGK2"? How will the v-2 know which input I have them...
Type: Posts; User: nicen_tech; Keyword(s):
Ok awesome! Thank you very much.
1. So when I am logging with my pc connected all I need to do is select the pids "CALC.AFR_NGK1 and CALC.AFR_NGK2"? How will the v-2 know which input I have them...
Awesome thanks! I sucessfully logged for my first time last night. With only the v-2 connected(BBL) I think, I logged two short clips. Then I connected the laptop to the v-2 to do try out the...
Ok, I think I am way more confused now than when I first started. I have been jumping back and forth between so many forum posts that my head is spinning! Is the v-8 bbl software for recording with...
Correct, I am trying to use a standard drive shaft revoultion sensor (ex. edlebrock p\n#91195) to monitor drive shaft speed(rpm) to calculate convertor slip or tire spin. I havent found any solid...
Ok I have the pid list setup for the pre-selected options but how do I setup the widebands and the drive shaft input(all analog)? I also posted this question under the wideband page because they were...
I see this is an old thread but these are the WB sensors I am using, what information do I put in and where? I really dont understand where this goes. I am in the s&t BBX , f2(scan) and was setting...
Thanks for the reply, thats what I am doing. I dont have the files saved in the V7.5 or V8 folders because when I go to save them they dont display available in the save as folder, I have them saved...
Its a V-2, it came with the car when I bought it about 2 yrs ago. I am just now getting around to using it and its overwelming to say the least. I am having problems getting the registration saved...
Just joined the forum and trying to get started with my efi live... Im a total noob when it comes to this kind of software so im sure I will have some questions and hope I can get some help. Car is a...
I have been trying to get my v2 back up to date and I have downloaded the latest software and am trying to get the v.8 software up and running. After programing the pids in v.8 and saving I switched...