My laptop is running Windows 7 ultimate 64 bit. I am thinking it was an issue with my laptop and not the software.
Type: Posts; User: Tom B.; Keyword(s):
My laptop is running Windows 7 ultimate 64 bit. I am thinking it was an issue with my laptop and not the software.
I rebooted my laptop a 2nd time and it started working. I'm not really sure what was going on. Everything works perfectly now. I am using the virtual com port settings.
Found the problem.
I just installed the most recent V7.5 update and now the RR control panel won't launch.
I was able to restore the knock software tables back to within 90% of the stock settings. Using the Road Runner RTACS was a major help in getting the VE and timing maps sorted out. I don't think...
1st time out and RTACS works as advertised.
Thank you. I wasn't sure if the FSV2 would communicate through the ALDL to the RR.
I have been using the serial configuration. I wasn't quite sure if I needed to anything different as far as physically connecting the cables from the ALDL, the Flashscan,and my laptop with the RR...
I wasn't sure if I left the flash/scan w/ widebands in the aldl port, or did I need to do something different.
Lc-2
I am going to attempt to calc VET with the RR. How do I connect my wideband to do this?
Yes. Thank you.
Found it. :doh2:
I am finally licensing my RR for Efilive. I cannot find cal_links.txt in the latest 7.5 version? Do I have to revert to an earlier 7 version to use the RR?
Good point. Although I haven't had any misfires, I will put that on a post it note so I don't chase the wrong cylinder.
Swap the wires for the coils at the PCM and change the injector bank assignment in the software. There is no other way to change the firing order.
I know this is an old post. I had the same problem with a 411 swap on an LT4. After modifying the tables using the 2002 L31 parameters, I had to zero out the {B6244} Knock sensor multiplier "A" I...
Thank you.
I must be doing something wrong. I cannot seem to figure out how to load the .calc vet file onto my SD card and have the V@ recognize it. What is the proper procedure? Any help would be...
Thanks Joecar and Lastcall. I copied the files directly to the pids file instead of the user configuration file. I should probably wear my glasses more often.
I must be missing something. When I copy and paste the calc_pids-2.txt I cannot see the additional pids CALC.LTFT CALC.LTFTBEN CALC.VE_Table. can anyone enlighten me?
Ttt
Thank you. I looked high and low to try to find it.
Help. I purchased a new innovate LC-2 that arrived w/o the O2 sensor. I have a compatible "017" O2 sensor with no connector that I need to adapt and I want to confirm the pinouts for the cable. ...
Thank you very much.