Hello all. I back probed the red wire and there's no voltage there, so much for believing in the V2 and the PIDs for reading the voltage correctly for me. I guess that's pay back for being lazy and...
Type: Posts; User: drthv8r; Keyword(s):
Hello all. I back probed the red wire and there's no voltage there, so much for believing in the V2 and the PIDs for reading the voltage correctly for me. I guess that's pay back for being lazy and...
Hello all. I followed this link in youtube along with a lot of reading. If the link isn't allowed here please remove it, I figured it'll help you guys understand just exactly what I've done. ...
Well as you can see it's a bit of rocket science with me...lol. Do you by chance have an LMM? From what I've been reading (and a lot of reading that is) the LMMs can be a bit fickle.
Hello, if you're referring to the picture where I'm pointing to. That's where I ran the black wire from the DSP5 switch to the firewall. I've heard some are having issues with that pin seating in...
I took the connector off the ECM again and I used a small needle to try to push the pin with the red wire in farther down into the connector. I even smacked it lightly with a hammer, I don't think...
OK I'll try that in the morning thanks.
Thanks for the reply but I did use a small straightened out paper clip to push the pin deeper into the ECM connector to make sure it was seated when I first started this DSP5 adventure, because I've...
Hello thanks for the reply. Yes I installed the pins in the larger of the 2 connectors. I don't know anybody locally to test my ECM with in their truck. I would think if EFILive 7.5 sees 4.98...
Hello Brain thanks for the reply. Yes everything is up to date on the V2:
Boot Block
2.07.04 Dec 12, 2011
Firmware
2.07.35 Jun 22, 2012
I know the ECM is flashed with the DSP5 tune...
I hope I posted this in the correct place. I could use some help please, I can
not for the life of me get my DSP5 switch to work. I installed the switch and
then did a full flash of my DSP5...