Search:

I have a general question regarding where (throttle%)people think the optimum point to command tip in fueling is?



The setup in question would be an LS2 low compression with a Magnuson 112 HH...

I'm trying to adjust the VVE tables on an E67 F/I application.
I'm trying to make a change from 100Kpa on up to 200Kpa. The first 2 IMTV 2bar tables, I made the change, and generated...

Very nice, I was able to see it in person, Jesse also brought an A/T equipped car a couple weeks later, and saw similar results....very impressive!

Ed

Have you tried increasing the B6101 table ( I think that's the right one) for predicted airflow on ETC vehicles? I had a similar problem on a vette making 12 PSI, and increasing that table made the...

I would really like that, I PM'd you my cell #
Thanks,
Ed

Nice! you're making about the same as ours with 2 lbs less boost! Good job

yep, 60lb Motrons, coolant temps are 185-190 but I haven't driven it real hard. It does have a 160 stat. I'm real happy...

no, really, I can literally hear it laughing at me......


Howard, yes P1-SC-1, Kooks 1-7/8" headers, 3" x-pipe w/highflow cats
I think it's pretty similar to yours.

Ed

Sounds good Ross!
Here's a couple pics of the car that's been sitting on the other side of my shop laughing at me for the last couple weeks:muahaha:

It's already made 625 RWHP on 6 PSI, with the...

a paper clip bent out and filed flat on one side works well too, you just have to "jiggle" it a lot


Ed

Any word on the release of the virtual VE tables update? just curious if beta testing went OK. I'm kind of antsy to try a 2 bar VEtune:Eyecrazy:

Ed

Very cool! I can't wait to get that tutorial and do some reading:D

Ed

That works, and allows me to make the changes.

Thanks Jes

that didn't change anything.....


Any other ideas??

Thanks Joe, I will try that, but I have the space for the 3 buttons, they're just not there. There is a blank spot on the toolbar where the buttons should be.

Really confused,
Ed

I'm trying to create a speed density tune, an I'm stuck on creating a boosted VE table. I cut and pasted the last column from the VE calibration, then highlighted the last column, and increased by...