Search:

Thank you so much Blacky. Everything worked great and was able to flash a computer. Again I appreciate you taking the time to explain it even though instructions are good I just realized when you...

I tried clicking on status and states, warning flashscan v2 not in dead poll mode

Greatly appreciate this and will give it a try.

Thanks for info. Tried performing what you suggested and unable to upgrade flashscan. Apparently when I check firmware version tab on control panel v8 software, it wont communicate with flashscan...

Im also have communication issues with V2 flashscan tool. Ive got version v7.5.7 build 268 and on v8.2.2 build 262. This all started when I just tried purchasing a license and redirected me to...

Thanks TreCool, worked great.

Thanks joecar. Definately not a tune issue, already have toque model adjustments on great. Its just with g8 tcm worse than stock by about 3 times and tahoe tcm works extremely great, especially...

After a year with 15lbs on of boost and e85 trans let go. I went through trans completely building it. Then right after for the longest Id been burning up 4,5,6 and hurting the other clutches on...

Have not done that. Will try that now and thanks for the info. joecar.

Having a problem getting transmission data. One for an example would be shift time error. I check in pids if its not crossed, then I can select it. Unfortunately almost all transmission pids are...

All answers were informative guys and thanks again.

Thanks again. Also when applying these resets, am I to see some kind of sign on scan tool that its reseting or of completion.

Hello everyone. Dont really post much, but hoping I can get some help. When I connect scan tool then start vehicle then select t43 module, go then to select fast reset, adapts reset, adapts preset...

Ive done a search and seems that maybe my situation may be different. At 16lbs and 12 degrees of full timing and full throttle only, will not set codes nor limp mode, but when at 18 degrees on race...

gmh308, any possible way I could get a base tune also. Thanks.

Greatly appreciated. Already PMd you.

My mistake. Thanks for info.

Any help would be appreciated. Tried looking for files in Holden Crazy, but no luck.

I wonder if the route Ill need to take is purchasing a used pcm and if so what info do I need to give to get a pcm that will will work with efilive. This is considering if this new pcm that was...

Hope I got this right.

I dont know how to put it in hear but I can e-mail it somewhere and if someone can put it in hear. Car starts and runs badly due to it being a n/a cammed and compression motor on stock file.

Had to replace pcm due to physical damage. Purchased one through and auto parts and had a bud with TECH 2 install a stock progam. Was able to read pcm but then when trying to program to car I was...

Can anyone help with the engine speed pin out from ecm not tach signal, but engine speed signal. Thanks in advance.