Search:

Type: Posts; User: Papalote; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    159

    THANKS, I will give that a try!! But after...

    THANKS, I will give that a try!! But after reading the instructions it looks like all I can do is record, not see live data as it happens, heck I have a $100 code reader that will give me at least...
  2. Replies
    4
    Views
    159

    Can I read live data V2?

    I cannot find info on reading live data on my V2 box, is it not possible?
  3. Replies
    6
    Views
    365

    Thanks, I will give that a look see

    Thanks, I will give that a look see
  4. Replies
    6
    Views
    365

    Yes the engine is running, light stays on

    Yes the engine is running, light stays on
  5. Replies
    6
    Views
    365

    Thanks, I went to a fair amount of effort to...

    Thanks, I went to a fair amount of effort to mount a large MIL light on the dash, was really hoping to use it (may have been a big pipe dream) I can find no reference to the U0073 in the DTC table,...
  6. Thread: LMM DSP5 tune

    by Papalote
    Replies
    8
    Views
    2,268

    On the LMM if it has DSP-5 and you do not have...

    On the LMM if it has DSP-5 and you do not have the original file when that tune was dropped into the PCM you have to start all over with a stock tune, you can only write a DSP-5 tune in a LMM, you...
  7. Replies
    6
    Views
    365

    Stand alone LMM U0073 code

    I am not sure this is the correct forum but I have a stand alone LMM and am chasing a U0073 "communications bus off" and wondered if anyone had any ideas, I have programmed all the "missing"...
  8. Replies
    3
    Views
    396

    THANKS! I have a stock tune from a library, I...

    THANKS! I have a stock tune from a library, I really do not need DSP-5, I am curious will the new flash have the original VIN of the ECM or will it assume the VIN of the donor tune? not a big deal as...
  9. Replies
    3
    Views
    396

    OK, I did not know the data went through the glow...

    OK, I did not know the data went through the glow plug controller, so I jumped that plug and I can now read the TCM, I get the "cannot read DSP5" error on the ECM, I of course do not have access to...
  10. Replies
    3
    Views
    396

    Error $0101 no data received

    I am doing a swap with a Duramax 08 LMM, when I try to read the ECM with ether EFILive or my scan tool I get a failure, the engine seems to be running OK but I have a MIL light and would of course...
Results 1 to 10 of 10