Any Chance you can help me out as well? Same Issue
Type: Posts; User: Prormk163; Keyword(s):
Any Chance you can help me out as well? Same Issue
Had a wire pull off injector 5, working on the maf issue. Seems like it's fine while logging, and my iat seems right (5 wire maf)
Alrighty well I finally got my Torque converter and new chain. I replaced them and its like a whole new animal, however after starting it up I now get codes po103 and po200. So I have to check my...
Well, I programmed the tune into my PCM and it ran the same. So I did a compression test while it was hot, with throttle body wide open and each cylinder was between 123-131 PSI. ...Edit.. Which...
Thanks, I will try it this afternoon!
Do my VE numbers look low for a cammed 6.0 with 317 heads? I'm out of ideas and ready to pull the timing cover off to see if my timing chain is loose.
Awesome, thanks again for your help. I know that every forum I've read you have provided guidance and insight so I appreciate all the time you spend doing that.
2012720128
Ok so this may be a stupid question but I don't want to regress, If I use runway highlighting and watch the narrow bands and my wide band and they show lean, I should lower my VE table in that frame...
Cl trimming was disabled. I enabled it and hope to do a log at lunch time. It does idle pretty well after some playing.
here is a log i did today.
20125
20124
here is the tune. I do have 317 heads on it as well.
http://www.compcams.com/Company/CC/cam-specs/Details.aspx?csid=1092&sb=2
224/230
Alrighty! I was able to do a few logs and some adjustments and its coming along. I am curious however that it seems pretty gutless at the bottom end. I am not sure if thats because of my cam/stall...
19594
Perfect thanks for looking at it. I did have the show units selected but it may not have saved. Thanks again. I'll prob try to do a log tonight!
The selected pids are correct for data column and row? And they match the values in main Ve for eq and b5001?
195881958919590195911959219593
So since i have everyones attention, can you guys look at my tune for calc.vet? I have read through the tutorials and i think i have it set up right. believe the...
This is good info.
Ya that's not a bad idea. My maf is a 5 wire with iat, not sure if cartridges include them. I could get a seperate one.
oh gotcha. Thanks for the opinion.
Well, 3" maf (76mm)
Is it worth running a maf? I've reas and read and it seems nobody has a definitive answer on any definitive pro's. I've noticed a lot of new molars run speed density? Does it aid in tuning precision?...