Greetings do you know how could I get it to work on truck OS
thanks
Type: Posts; User: miguelc; Keyword(s):
Greetings do you know how could I get it to work on truck OS
thanks
did you get the A6 tap shift to work?? I have a truck wiring (2008 scalade)
Greetings
Im gonna start dealing with vvt, I ordered 400 cam ( 210 intake).. Do you have any pointer so I dont borke an engine and make the most power on the below 4000 rpm range?
By the...
by the wa, since all stuff and calibration ... all hardware is form a 4WD silverado. Is there any way The ECU triggers the 4wd low signal? I got no body control module
Tps stays high on scanner, it evens launch hard but shifts at low rpms
Greetings form Mexico
I did a e38 standalone on a Fox mustang. Car was running Ok and then it started to shift very low at WOT. The car always had a ISS code but worked OK. Do you know hoy I can...
Greetings, I am tuning an L5 colorado.
At 10000 hz the afr goes leaner and leaner, we swaped for a bigger fuel pump and a 58psi regulator. Now fuel pressure is constant at 58 psi and the AFR...
by the way, wiring and ecu,tcm are form a 2007 silverado
Hello everyone
I disabled VATS, used a 100 ohm resistor on he black and yellow wire. the car was running, then took it to a 3 min ride.... after that the car only starts and dies and throws...
greetings
How do I diagnose a faulty ECM? It seems that every sensor hooked up to the gray connector doesnt have a 5v supply, also tps reads 100... could you help me, my boss doesnt want to...
Thanks for your answer. I do own an interface.
Could you please point me on what tables/ parameters to modify?
Or is there some transmission files I can compare?
Thanks again
Greetings
We plan to do an engine swap, since we got a 4l60 trans and a genIV engine. Do you have theTCM file to do this? or could you tell me a shop that works on this conversions?
thanks...
Greetings
I just wired two walbros to the stock power line. It shows the code even I select no error reported and dissabled the code U0109
do you have any idea what I could do? maibe a resistor?
Hi everyone
We have done like7 trucks with 4l80, then two of them (they have lsx engines 427 and 454) are throwing this code out of nowhere.
we tired using a new vcm and it didnt work
...