Search:

I have one

Here are a few pages from the instructions found on the AEM website.
X-Series OBDII Wideband UEGO AFR Sensor Controller Gauge | AEM...

It's very disappointing EFILive doesn't have this capability.
Also very misleading that AEM suggests it does work on their website.

Are there any threads discussing the new AEM wideband that connects directly into the OBD2? AEM says it's been varified to work with EFILive but my search came up empty handed.
I'd like to daisy...

I was comparing my older cal pid vs the new version. I noticed the low and high of currently used pid are slightly different. Would this have any affect on my afr readings on my V2? The monitor does...

It seems to be working correctly now.
I am guessing the update was all that was needed .
Thanks again Joecar.

I updated to the March 2016 public pre release.
I have a V2.
I look forward to testing.

The scantool is not freezing.The afr pid is just stuck on a random number.
I believe the V7 build is from last fall. V7.5.7 build 282

I just don't understand what has changed from the summer of...

I don't know the answer to that. I assumed if it was on it was doing it's job.

I an grateful for you time. Thanks for helping.

No change. The pid is froze
I checked for updates and firmware updates and it says I have the latest.
Sorry I can't seem to find the SAE.LAMBDA

19576
I am using the calc pids file you posted.
Build 28219577

I have confirmed aux output voltage from the afr monitor is working correctly. It reads 4.5v in free air and with the car running it was fluctuating between 1.8v-2.2v on my meter with an afr in the...

I tried it tonight and and stays on 11.1. I'm going to get a meter and double check voltage output of the afr monitor to confirm it's working.

Yes I did.

Just as I was going to screen shot my pids I double checked to see the pid parameters and now its valid!
I hope to test it later today.19568

I replaced pid txt with your version. I get this when I try to add the pid now. I assume I need to delete the bottom 2 somehow.

I have the E67

Here it is.

It's been a while! I am looking for a little trouble shooting help again. I am running a new engine set up now and its been a long time since I have datalogged. I have forgotten most of what I had...

Thank you joecar.
The formula works great.
For anyone using the new NTK air /fuel monitor (model 96604) the above formula is what you need!

Still hoping someone would be willing to help me out with the proper calculations to make wideband read correctly.
I'll keep reading.

Sensor reads 14s at an idle on the NTK monitor that the sensor came with. Sensor is new. Yes the sensor goes to 20 in free air.
I know lead is not good for them but they last a while to dial in the...

Vp c14

Thank you. That got it working. Unfortunately my formula must be wrong. My afr is reading 4 points to low. NTK suggest {(vout-0.5)x2.75}+9

I have:
*CLC-00-003
AFR 9.0 ...

Oops.

This may be more helpful.

Can anyone see where the error might be? Or suggest to me what I am doing incorrectly to cause this message?