Will do! It'll be October for me. Valves came in today shooting to get the engine back in for April dialing back in. I'll be our there with some 5th Gen Camaro guys. Robert Taylor I suspect will be...
Type: Posts; User: Blue70SS; Keyword(s):
Will do! It'll be October for me. Valves came in today shooting to get the engine back in for April dialing back in. I'll be our there with some 5th Gen Camaro guys. Robert Taylor I suspect will be...
Mmmm.... got an entire box of plugs with 3 heat ranges here too. That was a mistake I made last year...... didn't pull the plugs on the 1st blower only run..... could have caught the injector...
Thanks! Good info.... still toying with the EGT sensors. 1 gauge can display 4 sensors and EFIlive will take two K type inputs or 4 0-5v inputs. Even monitoring 1 cylinder per bank would give useful...
Have you found any benefit in datalogging using EGT sensors to assist in dialing it in for mile runs and highlighting potential problems before they get worse? (like bad injectors or cylinder...
What is the "336"? Is this the gear ratio or a multiplier used on the "gear_ratio"? (so if my rear end gear ratio is 3.25, would I use 325?)
Or, if I'm interpreting correctly from previous posts,...
How were you able to log gear position? Auto or manual tranny? (looking for manual in a 2010 Camaro, TR6060)
Has anyone confirmed the E38.VSS_DMA works on the E38? (2010 Camaro SS here with an E38)
What kind of fuel, boost, timing, and AFR progression did you have to run for the mile? On a 388LSX in a 2010 Camaro, I managed to warp all my intake valves on the 2nd run at the same event (Oct...
V8 Software: V8.2.10
FlashScan/AutoCal Firmware: V2.07.128 (Nov 03, 2017)
FlashScan/AutoCal Boot Block: V2.07.007 (Feb 07, 2014)
V7.5 Software: V7.5.15
I'm abandoning my Dell Inspiron 7537...
Thanks, I'll try to start a thread to see if anyone has successfully used the laptop I'm looking to purchase.
3 questions regarding the Nov 2017 public release:
1) Is Windows 10 a complete "non-issue"?
2) Are there particular brands/models of Window based laptops that work "out of the box" with it?
3)...
I didn't see any changes by modding the table. Wondered if I was missing something.....
New problem..... trying to flash my tune on the dyno and I get "Your Flashscan interface cable is not yet licensed to reflash this ECM" Other screens show the controller will be locked if I flash...
Great, thanks!
perfect, thanks!
The BBX "Space Required for Configuration Files: 92%" is displayed on the BBL Enabled Controllers page if that means much about how much load the USB was taking.
And on the USB port that...
21327213282132921330
The widebands are Innovate LC2 (one for Bank 1 and the 2nd for Bank 2) and I think it is cascaded (been a few yrs). A 4 pin connector brings it to a 9 Pin Serial with a Null...
My PID "WO2AFR2" won't log, but "WO2AFR1" will. Known issue or am I missing something? In my V8 chart I'm logging both digital (serial) AFR inputs selected from "Digital - External Digital/Serial...
Thanks!
Thanks, after digging a bit I finally figured out the "o" in front of the AD1, AD2, AD3, AD4 wasn't denoting a place holder, but they're usable in equations. With the E38 ECU is going past 28...
I suspected that might be the case in hind sight. After a long day of tuning and an extention cord..... might explain the usb problems. I knew about the inverter problem.
Can a 2nd Chart page be added in Version 8 like in version 7.5? In version 7.5 I was able to use tab A for gauges, and both B & C for charts. Also is the V8 chart limited to 16 items to record, or...
So after more testing on a separate laptop, I was able to get the smaller gauge USB cables to work and data logging in version 7.5 does not hang. It does however have USB 2.0 ports.
If I make the...
where can the 2.02.04 driver be found? Or better yet, the 02.12.26 most recently recommended. Nevermind... loaded the Beta versions, thanks
I have V7.5.7.245 on my wifes computer...... is there a way to install the firmware that correlates with that version? That would confirm if the V2 is a problem.