Search:

Where can I find the actual terminals for the x3 connector?

Well Taz, GM308. Thank you for your input, it is really appreciated. I started out with GM308's file for testing as it was the last one Pat put into the ECM/TCM...

The problem was still there in...

I do not have the runtime parameter in my software, just an enable temp... Which is set at 493*F

In my software, the closest to "TCS max engine torque" is a variable described as "TCS Delivered...

In HPtuners... All I can do is set and Enable/Disable that when enabled let the TCS system disable the BTM.. I also have a table for BTM limit based on Vacum vs TPS... This table is maxed out at...

I cannot answer the "B2512" question because I dont have EFIlive... But the torque reading from what I understand is calculated torque... This calculation can be modified so that it outputs a lower...

Other than the data, there is no difference really. Maybe a small diff in ECT from heat soak, but all else the same. This includes dyno settings, and pedal position.

What you are seeing is the...