Thanks
Sent from my iPhone using Tapatalk
Type: Posts; User: MN C5; Keyword(s):
Thanks
Sent from my iPhone using Tapatalk
Turbo the Silverado, just don
Well that's not going to work as they share the same ECM I guess. Wonder if a 2018 ZL1 E92 ECM would be a candidate to Swap. I probably should have went with a F-150 5.0 as it is more mod friendly. ...
I'm wondering if anyone could direct me or provide ECM pinouts for a 2019 6.2 Silverado and a 2019 6.2 Tahoe both with the 10sp? I'd like to see what's different, knowing I'd be forfeiting the...
I had the same issue on my Denali. I resolved it but I don't recall the tables I used to do it. I'll try and get a look in the next day or two and PM you.
Can someone point me to where I could obtain E92 Pinout Information. Just purchased a new 2015 6.2 GMC and want to hard wire a Ethanol sensor to the ECM.
Thanks
The Speedo, BCM & TCM need to have compatible OS's. I believe the Speedo gets its signal from the BCM, I had it a bit easier swapping a 6L90 because I was able to use a factory harness from a HD2500...
I too used Steve's services for a boosted E85 SD tune with Great Results. Highly recommended:cucumber: Only took him a couple of hits to dial in my rig with almost 20lbs of boost.
Went to a...
Very Nice, I'll have to pick that issue up.:cucumber: Nice job Howard
Does anyone have one or a way that's faster than cutting and pasting? I'd love some help...
I had some trans issues with mine until I went Mafless. Seemed to cure all of my shifting woes.
I also had the TB slamming shut under high boost too, so you may want to check that. I switched...
FWIW You can work around it a bit by limiting the amount of timing being pulled.
There is a lot of mis-information floating around about MAP sensors. Especially the 2.5 bar sensor. I looked for one but never located it. I'm using a 2bar up to it's limit and PE beyond its...
Super cool, now I can have DD timing and at the flip of a switch a Race Tune Timing Table.
One who knows little but talks a lot:cucumber:
And some of your best customers spend months on a perfectly fine VE table.. lol
That was fun to watch, he did a great job.
Flashed the new OS and everything works fine. Weird, but he11 it runs great now. Removing the MAF from the intake track moved the boost up 2psi from the 18.8 I was running.:rockon:
Which TCM tables are affected by dyn/cyl air? You lost me, did I miss an update with more tables..
Thanks
I don't know for sure what is the "MAF xfer"?
I do have another OS I can flash, its worth a try.
Tried again today, no such luck. It puked after about 1.5 miles into reduced power mode. It also threw a MAP P0106 performance code as part of the reduced power mode. I went through the tutorial...
Thanks for the reply! I'm trying to understand how tables C0803-06 affect the tune.
0803 "Used by the ETC diagnostic tests, this table defines the maximum expected measured airflow for a given...
I'm having some issues with tuning MAF'less and was wondering what opinions there were on this topic.
B1099 shows a gms/sec limit of 2455.2471 at 15,000hz and C0803-0806 show and upper limit of...
Yes, my IAT was relocated as part of the Supercharger install.