Thanks for the reply Ross. I guess I am a little confused. I see in the release notes that this beta software that I installed supports CMF. I checked to be sure that the CMF .inx and .dat files were...
Type: Posts; User: 2006Cummins; Keyword(s):
Thanks for the reply Ross. I guess I am a little confused. I see in the release notes that this beta software that I installed supports CMF. I checked to be sure that the CMF .inx and .dat files were...
Just out of curiosity; it's not pressure that you are hearing, is it? I have found that too much pressure before boost causes a noticeable rattle. I have never been able to run enough timing to...
SOTP and smoke showed no noticeable change. Made a long log and after a quick review didn't see obvious changes.
Set the entire 6270 table to -5 and didn't see a difference...
Any hints?
I had been think of a setup like that too. The more more I thought about it, the more it seemed like it just might work. Thanks for putting the theory to life! Looking forward to seeing how it turns...
Ok, thanks. I'll watch the icon.
I found that my problem is only when looking at charts on the dashboard - it doesn't show any data when connected and the yellow monitor button is pushed, but does when recording. I can monitor data...
No real time data...
I am having a similar problem also. I can record just fine, but cannot monitor. When I hit the yellow button it says that it's paused, and does nothing. It has been this way for a couple of months I...
I enabled mine with a starscan a while back. Whenever I flash with efi it goes away. I have to re-enable it with my programmer if I want it to work.
Worked for me. Thanks!
I will give that a try, thanks.
Just updated to the latest public v7.5 and v8 software release, and checked for updates. Firmware: 2.07.26 (Mar 28, 2012). Bootblock: 2.07.04 (Dec 12, 2011). Config files: cummins cm849 (apr 16...
12896[/attach
[attach=config]12897
Ok, ok, so it is not really NEEDED. But, I don't NEED 600hp either.;) My reason for WANTING it is to help with tuning. I can have my current tune on one setting, and then have four other slightly...
Thanks.
Just wondering if there is a rough time frame when we will see switchable tuning for cummins. I am really looking forward to this to help with tuning.
Mike
Thanks. I'm really looking forward to switchable tuning so that we can try a few things during one quick dyno session. Again, thanks for your help.
Hi, Les.
It started out as the first tune you sent me, and I have made 53 revisions to it since then.
No, it was a dynojet 248c
With my dyno experience I would agree that correction...
Made a couple of dyno runs at the ITD dyno day this weekend. I'm about where I wanted to be for power, but still have some work to do. I was hoping to get a good video of the run to watch smoke, but...
Dyno run 3/17/12:
http://youtu.be/4CTWZ2z_YYg
Thanks for the help guys. It's working now!
Ok, I was able open config under V8 while in the V8 tune tab. I found cm849 and programmed that to the V2. Now, the options file under config in the V2 says march 12th, but there are no config files...
I just opened the V8 with the V2 connected, hit f5, then f3. There is no "cmb" to select - just a page of "unused." The "config files" listed under the efilive explorer are dated jan 18th, jan 5th,...