Going by tune posted above:
24597
What's the temp when STFT begins?
Type: Posts; User: voda1; Keyword(s):
Going by tune posted above:
24597
What's the temp when STFT begins?
Disable B3801
My B5914 low spark table is using {link: GM.DYNCYLAIR_DMA} but the scaling only goes to 1.00 Where the PID data collected in the log shows max of 4.16???
How can this be fixed?
22983
open...
When opening a stock 97C5 tune file in hptuners the boundry value is shown and quite different from later values.
7.22 boundry and 4.78 normal(B3702)
22741
By utilizing the 2 external inputs of my V1, or with the converted EGR and A/C inputs. Could monitor camshaft, crankshaft sensors as well #1 spark and #1 injector. Does the scanner support enough...
What version of the tuning software are you using here?
Can't find a CALC.MAFT map. What is the data in the Value column above?
When configuring LS1A for OL/MAF what determines what is controlling commanded fuel, B3605 or B5001?
B0120=0
B3801=disabled
B4205=140c
Photobucket delete on the maps on first page. Need updated.
pdf was made. see post #48
Is that in all fuel trim cells or only cell #22?
The recorder does not seem to pick up any changes made while using the DVT controls. Is that correct or not?
Using v7.5
Why use analog when FlashScan accepts digital with fewer issues?
Could you post up that .map file?
On competitors website forum it was suggested to tune the PE by engine load.
Settings:
B3613 MAP enable to 85 kPa
B3616 Throttle to 10%
? ramp in to 1-1.25 (Did not see any ramp-in parameter...
Looking for an application that automatically synchs files (tune, logs, notes)between my laptop, home desktop, and work desktop. What are you using?
For early Gen3 the the EOI was 4.77 x 90 = 430 deg, 70 deg. difference than with the 5.55 figure.
Links:
http://www.hptuners.com/forum/showthread.php?32510-Injector-Timing-Reference-Periods-refereencing-what...
Followed steps listed above but the FlashScan was immediately recognized when plugged in. Went to the device manager and installed the Win-2K drivers. Everything is working OK now.
Thanks
I no longer have that version. Is it available somewhere yet?
Ok found the 'EFILive Flashscan FSP' device under the the USB Controllers section of the device manager.
Trying: Right click --> Properties--> Advanced then check Load VCP (adds a virtual com port...
Having same issue after installing v7.5.235 software(upgrading from .170).
When plugging V1 into computer first time the balloon pops saying device install successful. However the device manager...
From post#15236(Calc.VET: correcting MAF and calculating VE) it shows DYNAIRTMP_DMA as required pid but can be replaced by CALC.B4901.
CYLAIR_DMA and DYNCYLAIR_DMA are recommended, are there any...
Get car on a dyno and work out the timing and fuel settings.
Or now that you have better understanding of tune and scanner tools you could do what many experienced turners
have recommended and...
Link does not work - shows:
vBulletin Message Invalid Attachment specified. If you followed a valid link, please notify the administrator
Were the O2's cycling any faster?