Search:

here are the instructions from GM service information site

Replace and Program Control Module

To program a replacement K20 Engine Control Module (ECM), perform the following procedure:

...

I was not getting a popup error when trying to bench program , just an unspecified error. I will try to replace/reprogram with the doner ECM in the vehicle next, I have not been able to find much...

Ill try with the doner installed in the vehicle then replace/reprogram with SPS and see how it goes. I was getting errors trying to replace/reprogram with an E92 offboard programming cable. So I...

OK in the doner ECM the calibration in flash is for that particular vehicle is not mine, my goal is to put my stock calibrations into the doner then I can tune from there. Basically I just want to...

Hello Mark here, what I would Like to do is this: make a Clone of my existing E92 ECM using a spare ECM. I have tried to Replace and Reprogram a used ECM with SPS with a MDI and the VIN from the Used...

Here is My 2015 Yukon XL E92 ECM the vehicle was built 06/14

17963

17964