Search:

Type: Posts; User: Lil Mack; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    10,156

    I haven't tried that site in a while. Did you...

    I haven't tried that site in a while. Did you check the preloaded stock tunes on EFI live
  2. Replies
    11
    Views
    10,156

    0411 stock 454 tune

    Try Holdencrazy.com. Large data base of stock GM tunes. Look at a 01 or 02 Chevy express 2500. Only time GM used a 0411 on the Vortec 454
  3. I have solved my no spark when cranking issue. ...

    I have solved my no spark when cranking issue.

    My setup is in a swap, l92 454 on 0411 pcm. It would pop a few times and stop sparking. I found that the ignition wire had been moved in the fuse...
  4. Replies
    3
    Views
    6,110

    PM Jeff "LEXTECH" he will be able to get you a...

    PM Jeff "LEXTECH" he will be able to get you a good starter tune.
  5. Replies
    11
    Views
    10,156

    I am going to try sending it now.

    I am going to try sending it now.
  6. Replies
    11
    Views
    10,156

    I am going to try sending it now.

    I am going to try sending it now.
  7. Replies
    11
    Views
    10,156

    I have a mostly Stock tune I can send. It's a...

    I have a mostly Stock tune I can send. It's a startup tune in SD with all EGR and emissions turned off.

    PM me your email
  8. Any update on this? I have a similar problem and...

    Any update on this? I have a similar problem and wonder if this was resolved.
  9. Replies
    2
    Views
    2,390

    I did not want to spark hook check every llad...

    I did not want to spark hook check every llad range as this would be very time consuming.
    Just was interested in what the common tred was.
  10. Replies
    2
    Views
    2,390

    Timing out of boost, low CR ls3

    Any sugestions on timing for engine when not in boost, on low compression motors. Currently tuning LS3 forged bottom end 9.5:1CR stock ls3 heads.
    Is it common to increase timing to compensate for...
  11. Replies
    0
    Views
    2,035

    3 bar SD starting tune

    I am looking to get my turbo f-body build on a dyno to get it tuned. It will currently start and idle on the stock H/C/I tune from before the build. Currently I can not get it to move to load on a...
Results 1 to 11 of 11