Search:

Type: Posts; User: Cougar281; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    9
    Views
    311

    Well, is the new one a NEW one from GM, or is it...

    Well, is the new one a NEW one from GM, or is it 'new' as in new to you snd from a wrecked vehicle? If the former, it may need to be programmed with SPS before efilive can flash it, if the latter, it...
  2. Replies
    2
    Views
    356

    I doubt you'll be likely to get much support on...

    I doubt you'll be likely to get much support on this, considering the topic, but not related to my overall opinion on emissions in the US, emergency vehicles like firetrucks and ambulances should...
  3. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    Saw the beta update and installed it, and can now...

    Saw the beta update and installed it, and can now open the tune - but in poking around, I saw something that raised an eyebrow.... parameter C1710 - 'Number of Post O2 sensors' the value as read is...
  4. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    Paul, did you see the new ticket? Sent from my...

    Paul, did you see the new ticket?

    Sent from my Pixel 5 using Tapatalk
  5. Replies
    4
    Views
    478

    I doubt it would be related to pulling the engine...

    I doubt it would be related to pulling the engine (other than possible harness damage caused during the swap). The fact that you had no indicator under the PRND12 and T/H & trans temp were non...
  6. Replies
    4
    Views
    478

    Sounds like the class2 wire to the TCM may be...

    Sounds like the class2 wire to the TCM may be broken somewhere.

    Sent from my Pixel 5 using Tapatalk
  7. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    Oh, derp, totally glossed over the bit about it...

    Oh, derp, totally glossed over the bit about it being a ford. VAG vehicles are similar in that there's a LOT you can change with the right tools. On the VW Jetta my wife had, using VCDS, I was able...
  8. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    What did he do to kill it? I know there are...

    What did he do to kill it? I know there are various things out there, but it seems it's not uncommon for the various 'foolers' to cause funky issues.
  9. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    I forwarded the e-mail in a short time ago, and...

    I forwarded the e-mail in a short time ago, and it seems it opened a new ticket (not really surprising), and this one seems to be URAK-5558-ANYF - there's nothing else in the e-mail to suggest a...
  10. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    Looks like OMNT-8555-PILR. Sent from my Pixel...

    Looks like OMNT-8555-PILR.

    Sent from my Pixel 5 using Tapatalk
  11. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    So I read the controller and submitted the file...

    So I read the controller and submitted the file to support about two months ago... I never got any sort of notification, but apparently the ticket was closed, but with zero comment. No yes, no, maybe...
  12. Thread: VIN and VATS

    by Cougar281
    Replies
    14
    Views
    1,961

    Well, no, not really. Yes, flashing calibrations...

    Well, no, not really. Yes, flashing calibrations to TCMs doesn't use licenses any more, but changing the VIN doesn't use a license on any controller. Using the TCM was more a cost/availability thing,...
  13. Thread: VIN and VATS

    by Cougar281
    Replies
    14
    Views
    1,961

    I had some time and a few T42's laying around, so...

    I had some time and a few T42's laying around, so I decided to try this - I grabbed a VIN for a Dodge Charger off ebay and tried to program it to a T42 with EFILive - it seemed to take it just fine,...
  14. Thread: VIN and VATS

    by Cougar281
    Replies
    14
    Views
    1,961

    Just changing a VIN does not use a license. ...

    Just changing a VIN does not use a license.

    Since it seems the VIN change you're talking about is something like putting a dodge vin into a gm TCM... No idea if it would work, but as there is no...
  15. I sincerely doubt that's possible. If by some...

    I sincerely doubt that's possible. If by some chance it is, it would of NOT be by way of EFILive.

    Sent from my Pixel 5 using Tapatalk
  16. Thread: VIN and VATS

    by Cougar281
    Replies
    14
    Views
    1,961

    Would need clarification from the OP on...

    Would need clarification from the OP on 'different manufacturer', bit assuming the OP means Chevy/Cadillac/Pontiac/Buick (different GM brands), then yes. I suppose up could changecrge VIN in a GM...
  17. Replies
    2
    Views
    1,347

    Welp, that tank was run down to near fumes while...

    Welp, that tank was run down to near fumes while being gentle (No idea where I'd even get 100 or 120 around here, and most out there said as long as you stayed out of the boost, it would be fine, so...
  18. Replies
    7
    Views
    623

    Well, yes, that would 'work', but I'm looking for...

    Well, yes, that would 'work', but I'm looking for a way to leverage tools I have better, rather than spending more money each time I need to do a 'one-off'. If EFILive was able to support scanning...
  19. Replies
    2
    Views
    1,347

    Knock retard 'feel'

    For the experts out there... How much knock retard under power does it take to 'feel something'? I just bought a 2019 CT6 3.0TT that I strongly suspect was filled with 87, while it requires 93. I...
  20. Replies
    7
    Views
    623

    I used the V8 software to send a small PID list...

    I used the V8 software to send a small PID list to my V2 to scan. I also tried using the V7 Scan tool, as well as the V8 scan tool, but to be honest, I don't have a lot of faith in the V8 tool either...
  21. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    Yes, I shut it down and waited for the timer...

    Yes, I shut it down and waited for the timer before continuing, and then after that, it sat overnight before being started again. It was Thursday evening that I read the ECM, but today that I hooked...
  22. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    So I updated to the latest release, and was able...

    So I updated to the latest release, and was able to read the ECM in my 2019, which I sent in. The odd thing is afterwards, some things seemed to be really ticked off. Onstar is complaining about five...
  23. Replies
    7
    Views
    623

    Well, I did and it didn't work - what I do not...

    Well, I did and it didn't work - what I do not know is if it didn't work because I had to select a specific GM ECM, thus it was looking for something specific to that ECM and failing for that reason,...
  24. Replies
    7
    Views
    623

    Scanning 'unsupported' vehicles

    So this may be a dumb question, but is there any way for EFILive to be able to scan vehicles/manufacturers that aren't supported using generic/SAE PIDs? For example, a 2012 Dodge caravan with the...
  25. Thread: E81 Support?

    by Cougar281
    Replies
    22
    Views
    2,577

    I must have missed something then... I tried to...

    I must have missed something then... I tried to read a 2018, but couldn't because of that... Is it no longer a pay thing, or something else? In that case, it was 'out of curiosity', so I wouldn't...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4