Search:

Tried to upload, selecting the e38 controller and it worked. Thanks for your help!

Wes

Yes

email sent

I have been selecting the e67. When I check status it said ok on e67 and not ok on e38.

Wes

Tried many times over the past few weeks. Updated Efi live and still no go. Done some searching but all diesel related. Tried alt keys but still no go. Wont unlock pcm. I know its something I'm...

Can I copy and paste the values in the spreadsheet to my tune or would it be best to make slight adjustments to my current numbers? 5500 lb 1997 2dr yukon with 383 4l60e, 0411, 3.42.

Wes

Thanks weatherman! I went through that tutorial and changed a few items. It did not work at first but after a few days the truck starts without hesitation.
Wes

I tried adjusting both of those tables with no success. Here is my tune.

When I start the truck at operating temp it will idle at very low rpm and die. If I aplly slight throttle it will start and run fine. What should I adjust to cure this problem?

Truck is a 97...

Went for another drive, the truck seems to idle smoother and the transition from idle to throttle is smooth with out hesitation now. Where I have a problem is that at WOT the truck seems to stumble...

After changing from Lambda to EQR, I see where I was way lean. No wonder I was getting the knock. I changed the table to read richer as you stated joecar. I will try again tomorrow after church and...

I changed fueling to EQR and made sure MAP was kpa. Where should B3605 be set to? I changed it ti how you see it from the AutoVE tutorial. Should it be 1.0 in all cells?

Thanks, Wes

Here is the log.

Spent a little time with autove today. Set everything up according to the tutorial. Drove the truck for about 30-45 minutes. Hide the less then 50 count cells, used the filter and copy and pasted....

yes

How do you log afr vs rpm vs map? Thanks

I have been watching my AFR since I recieve my serial cable TAQuickness and noticed that when cruising at 70mph in OD my afr is ~13.8-14.3. That seems to be a little rich and curious what I need to...

Was attempting my first AutoVE last week and noticed that I only had hits in my BEN map under the 15 column.

Under PIDs I have intake manifold absolute pressure selected, units are psi kpa and...

Updated firmware software and now afr is reading the the same.

Swapped yellow for brown, still did not read the same but it was closer. Would a taq cable benefit me?

I did program for log works.
I will go switch the yellow for brown and report back in a moment.

I am using the autove pid selection.

I believe its analog. From the 2.5mm out jack on the lc1 I have a 2.5mm to something adapter, then a something adapter to usb. and I have the yellow wire to...

Installed lc1 today. Went through the new install procedures, everything seems to work ok except I still have my original problem.

log works reads ~14.6
efi live reads ~20.5



Wes

I have not powered it up.

Just recieved my new lc-1 from innovate. Old one quit, sent it to them for repair and got a new one in the mail at no charge. Here are some pics before a put it in the truck seem correct to yall?
...