Search:

Max out B7500 Table in V7.5.

Doesn't it default to #1? I confirmed this on a CM2100 the other day as it doesn't give you an option to set a tune when flashing a CSP.

So what pump data parameters is changed? I wonder if they will make those parameters available to be viewed/changed VIA EFI software and not have to use 3 party programs.

You'll be fine. I use that same .03 file for all my 68rfe 18's

According to that CAL and OS you have a 2015 CSP file. So those numbers don't help much.

Remove the (- DTC) in the name of the file. So instead of (52120818 - DTC) its just labeled as 52120818. Does that makes sense? Didn't work for me until I renamed file.

Might be a bit tough to get help on here since doing so is illegal :nixweiss:

Oh okay well good to know.

Once again super helpfull thanks Jim!

Anyone have a .cax for exhaust brake memory on CME 2018 OS's? I have them for my 2015 files and is convenient for customers that want EB to stay on after key cycle. Thanks!

So if I have a customer currently running a cp4 tune and goes for the cp3 recall. It will require a new base file to match that pump? Or can the FCA current flow just be changed? I know I had a few...

So out of curiosity if the 19-21 trucks have the CP3 recall done and are currently tuned with "Old" cp4 software they will require a revision for new pump? Didn't know if that was just a OEM stock...

That's perfect. Thank you

Anyone have a stock 2018 Aisin stock file. DO90067.03 OS 32.18.01.00 Thanks

No changes were made yet was just trying to save my stock file so I can revert back if need be. Forced correction now says okay to flash. Thanks

Read a clean stock file via Calterm from a 2018 6.7 Ram. Converted to .ctz with Xcal convertor. Now getting Checksum invalid. Apparently OS isn't supported by EFI live so may have to find alternative...

Working on a 2015 Lml and customer is requesting the exhaust brake memory stays on even after key cycle. I know with some of the Cummins controllers this is a thing. Are we able to do it with EFI...

Try this

I know on the Cummins ECM you can preset a CSP level when flashing and it will stay on that level. On the DSP if I set the tune level with my V2 through CAN switching will it stay set on that level...

Hey anyone have a stock file for 2018 G56 Ram? DO90068.04 - OS32180202 - 32350830AE. Thank you

Building a few of my own scripts for different LML OS's. Do all the segments within that OS have to match as well for it to work correctly? Thanks

Ok ty.

I hear that swapping OS systems between the 2350B ECM's is apparently okay as long as transmission selection is correct? Reason I am asking have a 2013 truck but a tuned 2014 file (Same trans) and...

Someone correct me if im wrong but pretty sure you need bench harness as they use different pinout then factory Dodge harness. Just went through this and had to send out and bench flash.