Lots of good info.
Thanks for posting :)
Type: Posts; User: kenkaru; Keyword(s):
Lots of good info.
Thanks for posting :)
Thank you Thank you Thank you Thank you Thank you Thank you!
1. I updated to the lates ver.
2. Still go the error "can not connect to pcm"
3. Got sad
4. clicked "Show PCM info" for kicks...
I was using 7.3.1... I'm DLing 7.3.3 so I'll give it a shot in a few.
Thanks again!
How to "Test"?
Thanks
Ken
Laptop decided to hibernate when it was at 100 of 128kb.
It was only off of the mains for a minute and a half!?
In the EFI-L help, it says it should only be a problem if it happens during the...
Assuming what I said above is true, how can I get it to run a different A/F outside of PE mode? ie if I wanted to add fuel to the 1500 rpm x 50 MAP cell to kill some bucking. or are there better...
Thanks! I'm viewing 3618 in Lambda and it's all 1.0's down a single column on RPM.
I had no clue about EQ and Lambda so thanks for that :)
So the car will always go for 14.63 unless it's in PE...
If B3618 is all 1.00's, what AF is it shooting for? 14.63?
Thanks!
I deleted the incoherent babbling I previously posted and narrowed it down to this:
Why would I get a BEN value of less than 1 if the cell is alread too lean?
more specifically:
In cell, 1200...
I can def smell fuel.
Thanks for all the suggestions. I have EGR! and AIR! so I wonder if they are leaking. I'll have to check it out. I need to take it for a spin too to see if it's only at idle...
I can't seem to get my LTFT's to budge from 25% at idle. Occasionally, they will drop to 9% or so for a few seconds and then quickly climb back up to 25%.
I have scaled down the VE table and it...
I saw something recommending changing the VE table to help warm starts with cam. That doesn't strike me as being the "correct" way.
Would B3632 be the proper way to lean it out? I do want to lean...