Search:

Well, I have been using the same V2 on one truck for almost two years now. It has always been up to date and I use 7.5 to tune and flash both my PCM and TCM. This is on a 2005 Duramax, LLY. So,...

Hey, well, I have a 2007 Colorado with the 3.7l IL5. I need to turn the ABS off, due to a solid axle swap. I can pull the little light out of the dash that turns the light on, but I also need to get...

Oh, haha. At least you got it figured out. So later this week I will be able to get an update and it'll be all better?

Thank you!

Again, sooooo much better than SCT, it's been a month and a half with an issue and they can't figure it out! Will EFI run on the newest Furds? I think there gonna be getting Bosch.

.26 I got all the soft/firmware figured out in my other thread. Everything is right from what I have been told. It just freezes, I thought maybe it was a slow process, but even letting it sit for...

OK, so now should it work when I go to switch tunes? Instead of freezing up?

I am up to date on the firmware.

I checked the box, looked at the V2 again, and it changed MRU PIDs to yes, it was a no.

Ok, got it all figured out. So I loaded up my DSP5 tunes to my truck, did everything on the V2, now when I go to switchable tunes, the V2 freezes up and won't do anything until I unplug it and plug...

OK, got it. Now, next problem. On the top of pg. 23 of the DSP Upgrade Tutorial it says to turn "Auto PIDs" on, I dont see auto PIDs on my V2. There is MRU PIDs, A/D PIDs, and Ser PIDs.

How do I get a higher version in the folder? There all older versions...

Nope. Not getting anything. Anyway I can manually do it?

Ok, I was able to get the V8 and the V7.5 to update fine. Now, I just cant seem to figure out how to update the Firmware.

BootBlock: 2.06.02
Firmware: 2.06.23

I am not up to date correct?

Maybe it's because my software isn't up to date, but I do not see a data files tab to format in Explorer. I will be updating shortly, no Internet on the road.

Will this issue have any affect on me...

I will be updating my soft/firmware in the next hour or so and will try again.

But like i've had issues before, what if I run into the "Bad Token" thing again when updating?

I did format with scan&tune, seemed like it worked, until I go to explorer to load the files to it. Then the codes again.

I am not using a SD card. I didn't think I'd need one, I only want to load what I need for this one vehicle.

I get the $0185 when I try to format. And I get the $0183 when I try to put files onto the V2. Err, well it could be visa versa. Either way, I'm getting both codes and it's not working.

Well, I have lurked around here for a while now, just haven't had the need to post before.

Anyways, I tried to do the custom OS for the DSP5 for my LLY Duramax, using the V2 as the switch. I...