The help and support given from others on this forum is by far the best i have ever encountered. It comes free of charge from an amazing amount of devoted car people. It would be nice if we could set...
Type: Posts; User: lq9nissan; Keyword(s):
The help and support given from others on this forum is by far the best i have ever encountered. It comes free of charge from an amazing amount of devoted car people. It would be nice if we could set...
Thanks guys, i see the external callibration using scan tool only on Taqcable website. makes better sense.
(The pdf is for serial, but the process should be the same,<setting ser pid>off. A/D pid on)
flashscan didnt come with serial cable, lm2 serial is optional part. So pretty much up the creek without a paddle, got me beat why the voltage calibrations wont take.
i dont have(cable), to get them is 3 days away unfortunately, is there a problem using analogue ?
version 2
Any suggestions on the following.
not getting correct reading from Lm2 on fs2, cant set voltage calibrations either. Through control panel on v7 set first voltage with 1618mV (aa battery)...
Not sure if i am off track here but, my main pc i use for learning (not the programming of pcm's) has latest software and the check for updates was performed, all the pid's seem to be undefined. The...
All done thanks Taz. that tune file certainly has done the trick, tomorrow i can get on with doing the fun part of tuning. Thanks heaps. For some reason i think the abuse management kicked in on the...
that sounds good, looked for the pinouts on the diag but shows switch with 5 ground circuits but no reference to which switch is PRND on the switch. whats me chances of getting someone to do a...
still trying for a case relearn, got me beat, 14 hrs of mucking around and the best i can get is a red header bar on the dvt screen saying transmission in gear. i think im done with this already
current load
refer to this thread for more detailed info
http://forum.efilive.com/showthread.php?16048-lq9-engine-transplant
case relearn will not function no matter what i do, is the splash supposed to open in a seperate window as the efi tutorial suggests ?
G1203 in system/fans, just check the turn on temperatures are not set 0
ok got 2003 silverado base modified and loaded, all functioning well, just need to get case relearn to take and im pretty sure i'll be well on my way to a much better drive, will keep posting with...
try system, fans,parameter, G1203 to auxillary if your using pin 42 as an earth to enable a relay, check your turn on/off settings are correct as well.
ok, dbw 10 pin conn. 9 in use. tac 10 pin connector. dbw 8 pin all in use.
dbw came with engine, app and tac came from harness & pcm supplier/ builder. i see where your coming from.
still need to...
the clutch switch, the switch in the vehicle is paralled with seperate brake switch it is 12vdc+ only when the cruise is enabled. connector c1 pin 33 i believe is fine for cruise. what about c1 pin...
Ok, will look at lq4.
does anyone have a stock lq9 (manual trans)(if it exists) .tun file for 2004-2006
hello all, long time no talk. my vehicle has been on hold for a few months. I managed to get things running quite smoothly after many many hours. However perfection still has not been achieved. I...
tun file
Well Said
first log, ign timing ?? going down as revs go up, no knock retard logged
http://www.lt1swap.com/2000harness.htm good link
sounds good, i dont really see a reason why i cant connect brake/clutch switch, car was factory cruise so all switch's are there, what do think about transmission setup in the tun file ??.
cheers...