Hi
Would you guess the pin26 input is active low or high ? Would the threshold be 2.5v ?
Type: Posts; User: Z06-GT3; Keyword(s):
Hi
Would you guess the pin26 input is active low or high ? Would the threshold be 2.5v ?
How to clone an entire ECM ?
We have a spare E38, and want to make a full (OS+Data+everything) copy to the spare.
Where to buy the terminals for the E38 connectors ?
Many thanks for the documents - It all seems to match up.
CPP = Clutch Pedal Position = pin26 of E38-Connector X1
Wasn't expecting it to a a pot.
So the final question will be.... ...
The car was built in 2007.
Customs loom as a good chunk of the stuff is missing eg air-con etc.....
Hi
So the minimum value for 'minimum throttle setting' is 99.99% ? A lower value is not setable ?
Angus
11131
1112611127111281112911130
I have these...
Hi
So what is the input pin on the E38 ECU which is the "clutch input" ?
If using EFI Live to set the parameters ? which page or where to find the parameters ?
Angus
You are right.
The GCU apparantly if it detects things aren't working - reverts to a fixed period.
So to summarize :
1. Which wire/pin on the ECU is the Clutch Switch input
2. What are the...
Torque Reduction
The E38's fixed stratergy would in most cases be just fine, but Geartronics are not happy about it as they can not control it's duration dynamically.
If the input signal (lets...
Simon you have been busy.
Sounds good - how did you mange to test it ?
Geartronics - you can email Neil on info@geartronics.co.uk.
Ign Cut
So the Clutch Switch input gets the job done.
...
I think I see a solution from what you describe.
Geartronics is a closed loop system.
So there are outputs for signalling Ign Cut and Blip.
Real world shift times are typically 50ms - 150ms...
Thanks Simon.
Most shifts will be without clutch, previous car need human to perform throttle lift/blip for shift.
This time will use a geartronics controller, so can interrupt the ignition...
E38 - Throttle Cut / Throttle Blip
We have a Z06 race car and we are swaping the Tremec gearbox for a MakTrak 6sp Sequential.
As it can be fitted with paddles for shifting, it would be good if...