Search:

Thanks for the heads up. The log was taken without doing anything (DFCO on etc etc). Ill do up another log as per the guide and can repost it. The weather is getting more and more humid as I live in...

Does this look ok?? Any tips?

Thanks for clarifying. Im looking at getting a 12v (cigarette type) laptop charger and I will now keep the inverter to power other things. The V1 ran no problems but didn't come with a warning like...

Hi all, I have just made a decent log file (2mb) so it wont let me upload it. I did general cruising and a couple of WOT runs over 200km/h. Just wondering if anyone is able to have a look and give...

On the instructions it says to check difference between output from OBD2 port and laptop power supply or damage to the V2 may result.

Can I get a 12v charger for the laptop and use it (not through...

I was going to mention that you run it under the dash. I have mine setup the same way but I also have 2 gauges (binnacle) which connect to the OBD2 port so swapping between the cables is easy and tidy

Made my own today by chopping up a 6 pin phone cable. Works perfect. A little bit of a tidy up and the cable will be spot on.

Is there a way to log 2 AFR's? I have 2 AEM gauges (one for each...

Cheers, Does anyone in Australia make or sell them?

The only serial port I have on the laptop is for VGA output :(

V2 says it cannot find WBO2 using analogue yet it will display the voltage output fine

EDIT: Ok now I have actually have a good...

Sorry to dig, but happy I found this. Wondering why AEM isnt listed in the list of WB's. Is using serial output better than analogue or is analogue fine?

Cheers for that. Tuner wanted to look aver the short trims so doing this massive drive I can get some good logging. Might even do a trip up to Sydney and get him to do it :)

Sitting on 130km/h...

Or point me in the right direction please.

Stupid question but what things do I need to enable to log short term fuel trims?

Can someone tell me what I need to log on the map?

Thanks

Thanks for the help. I see what my main problem was, H0102

Cheers again! :)

I have just installed a 3.91 diff into my M6 (was 3.46)

Speedo was correct before the upgrade. I then changed the settings using the "Speedo correction" button and I cant get my dial to sit...

Thank you, must have been doing something slightly off track. Now just waiting for my email from who I bought the V1 from and I can redo my Ute :)

So what do I have to do to make my V1 work on Win7 x64? (USB drivers)

Cheers