Hi Cindy
The below comments are pertaining to the recent tables added. I hope it helps.
In closed loop Modes 0-6 there are 4 ADDITIONAL tables that are responsible for turbo Max positions....
Type: Posts; User: engr7581; Keyword(s):
Hi Cindy
The below comments are pertaining to the recent tables added. I hope it helps.
In closed loop Modes 0-6 there are 4 ADDITIONAL tables that are responsible for turbo Max positions....
Hello !
Does anyone happen to have OS 12678650.
It for a 2015 Silverado WT 3500 6.0.
I do not care about the rest of the segments. I am only trying to swap fuel system segments around.
...
Thanks for all the help. I figured it out in hex. There is a slew of tables not mapped out for turbo control alone.
I have been fighting an issue on some LML trucks and in pretty much in all operating systems where the turbo desired and actual boost do not follow eachother. Please see the attached log file. It...
Problem solved. It was a faulty cascade valve lifting and reseating multiple times. Found it on return flow data. Thanks to all for the help.
pay no attention to the label it means nothing. The tune has other files in it. I am focusing on tune #1
It on a fully loaded dyno run it will hit 1350F if left long enough.
Yes it starts to surge at the bottom of hills and at coming off the top of a hill. Basically during transition areas.
I can't figure out this weird cruise surge issue. This is on a manual transmission truck and the surging only shows up around 1600-2300 rpm with cruise on. Remove the cruise from service and truck...
Can full flashing any LML affect operation of the trailer brake controller if the segments are not all correct. I have a customer stating that their trailer brake controller stopped working sometime...
Maybe I missed it, but LML A50 support is not available as of yet correct? Only read and scanning? Thanks in advance.
After fully flasing a 2013 LML with the OS 12645750 (all segmenst matched) and making a few changes to the file, cal flashing, driving then cal flashing again, on my last cal flash the truck got a...
Nevermind, figured it out.
How did you block the code? I think I have all the 2013 LML files and do not see any codes that can be blocked in the Engine Diagnostics section
Any resolution to this? Whatever is causing it has rendered the V8 tool useless to me. I can't use it without getting the errror message. Can't buy additional licenses, can't full flash dodges. I...
It does. I am going to replace 11720604 with 11720809
Thanks! Yes they are both auto trans files. There are just a few differences in the folders under internal flash is all.
I am building a CSP5 tunefor a 2009 6.7 and my OS is 11720604. It is not one of the ones listed as able to be upgraded to CSP5. Can I just use one of the other ones that are available such as...
The VIN is 1GT120E80FF511484. It is a 2015 Denali HD. I have the files from 4shared and the only part number I can get to match up is the boot number. Are there a bunch of 2015 LML files out there...
Does anyone have a 2015 Denali HD stock file? I downloaded the ones from 4shared but can't find one that matches up the correct main OS or Engine.
Thanks for any help!!
Got it figured out! Thanks for the help it was beneficial.
When selecting the correct LML base tune are we required to match up only the Boot, Slave, Main, and Engine part #'s like the LML quick start guide says or is it required that we match them all up?
...