409 OS solved my issue. Thanks guys for the input and support.
Type: Posts; User: nm2769; Keyword(s):
409 OS solved my issue. Thanks guys for the input and support.
Thanks I appreciate it.
Could you send them to nm2769@gmail.com
Thanks
Still no luck getting full fueling. Does anyone have a stock 11352409 48re Auto OS someone is willing to share. Searching this issue has led me to others having this similar problem with with some...
There was a old thread of someone having a similar issue that I am and it was recommend to him to do this and it fixed his problem. Figured I'd give it a try just haven't put it back to original...
I think something has gotten corrupted maybe something the ECU is seeing when its running. I don't know. I flashed the old tune back in after I started seeing the fueling problem. It is doing the...
Thanks I will give it a shot and see what happens.
Still can understand why it was fueling fine then did an adjustment to the trans 3-4 shift and took some timing out of #3 and now this is...
Your not setup to accept PM's got this error
Errors
The following errors occurred with your submission
blackshadow has chosen not to receive private messages or may not be allowed to receive...
Do you have any of the other codes from these slides? Thanks
Tune and last log. Thanks
23169
23168
Been doing some logging and have found that when MINJSTAT_F 7 is active I'm limiting Fuel. Then it goes to MINJSTAT_F 19 and then I have fuel fueling. From what I have read 7 is normal and should...
Guys I need some help. I have been searching and reading every thread I can find on why tunes lower commanded mm3 and duration at 2800rpm and above. I have checked every limiting table that anyone...
Paul, the errors occur at startup. Both V7 & V8 get the errors immediately after the program starts. V8 has what seems like an endless Access Errors at startup and I have to use task manger to force...
After this latest update it has left V7 & V8 completely unusable. Tried doing a complete uninstall and deleting all files and registry entries and reinstalling. Same issues V7 gets a Stream Write...
Sorry it was a computer issue. Tried to use anther tuning software and it was having errors as well. Just use that laptop for tuning so I did a reset and all is working well now. Not sure what the...
Thanks for the tips but unfortunately that did not work. Will be creating a support ticket
V7.5 & V8 unusable after this update. Tried above instructions, did not help. Tried uninstalling and deleting program files and then fresh install. This did not help either still getting same errors....
Please Delete
V8 still wont connect to the ECM. Tried everything I know to do. Any suggestions? I want to purchase the Cummins license but not going to spend the money if it wont work.
I made some headway this evening but still isn't working 100%. I uninstalled the V7.5 & V8 software from the lap top. Used IObit to clean any remaining files & registry entries. I down loaded and...
The problem I have with saying something is wrong with the truck is that a $15 OBDII scanner works perfectly. If I plug the V2 in without the computer it powers up fine. If i press any of the buttons...
No it will not recognize the ECM V8 pops up a screen that says No ECM Detected.
I though that was the case that you can scan just not flash without upgrade. I am running the December 2015 release of the software and the V2 has the correct firmware for that software package.
...
I can not get my V2 to connect with V7.5 scanning tool. When I try to log my CM849 the V2 goes into pass through mode then just the yellow LED is lit. The V7.5 scanning tool shows that it is only...
I know it has to be something simple but I just cant seem to figure out what the issue is. I am well versed with V7.5 scanning and the WBO2 data is working in 7.5. I have just started using V8...