Anyone?
Type: Posts; User: Sleeping; Keyword(s):
Anyone?
Can't seem to find the info needed for the Default minimum pulse width for these injectors. By chance anyone have this? I have set eveything else for them if someone could take look to verify all...
Any problems with cutting the harness so there is not all the extra wire and soldering/heat shrinking the wires that would cause readings to be off?
Need to get wideband for my car and was wondering if having one for each bank will be necessary. If so is there any way to use 2 sensors as the narrow bands also. I no longer have my rear o2s. I have...
Just some nitto everyday tires came on the car have not bought new tires for it yet
Thanks now just got to get it to hook with the 4.10 rear end goes through gears fast.
Here the dyno graph
10926
Well its in a rx7 that weighs maybe 2800lbs so hope it does little better we will see soon. Im still up in the air on weather to turbo or do heads and a cam.
Alright just talked to my buddy the 340hp is corrected to dynojet numbers. I dynoed on a super flow with heavy rollers for diesel trucks. So the superflow number was 307hp I think. Im waiting on the...
Would not mind hooking the maf back in if its going to be better overall. But Im lost on what your guys are talking about. Im still new to all this and just now figuring out bits efilive. So would...
No real mods just a ram flywheel with ls7 clutch and custom air intake. The motor is out of a 04 gto but has 02 camaro manifolds on it. That go from either 2 1/4 or 2 1/2 into a y 3inch out to a...
Car is just a weekend car and track car here and there. It is just stock for now. Car made about 340hp corrected. It was throwing a code for maf circuit so ill have to go back to my old map and diag...
I set the high and low octane maps the same. What are some advantages? COS? Custom OS?
Just had car tuned and was wondering if could get someone take look at my map and log. The maf went bad for some reason on the dyno so just went to Speed Density. Was first time using the efilive so...
So would changing the pulse help me in anyway instead of wiring a circuit up like the attached picture for my 04 GTO swap?
10710
What about wiring a 2 speed fan instead of 2 fans on a 04 gto pcm with only a high-speed signal wire?
Using a 04 GTO pcm in my rx7 swap and the pcm only controls the high side. How can I wire them up to utilize both high and low? Is there any settings in the pcm or pin I can add to the pcm that...
Got figured out was a mess up in my wiring of the harness.
Ok thanks for the tune. Is there a spot on here to find tunes in future?
Yes the engine and harness is a 04 gto auto that I converted to a manual harness and wired into my car. And the trans is from a 05 gto. Where do I find a stock m6 tune and when I reflash do I have...
Well I went through all the harness and took out all the auto and swapped in all the wires for the m6 trans. The os is 12587604. But how do I change the pcm from auto to manual?
Its a swap into a rx7 the pcm is from a 04 and I believe the trans is from a 05 gto. DBC?
How do I go about doing this? I looked but im not sure where to find the os I need. So i do just s full flash and then just add my vin in?
Trying to load my pcm calibration for the first time and will not connect. This is my first time using this what am I doing wrong? I link the cable as in put in serial number and what not under the...
What about the road runner feature?