Search:

Type: Posts; User: Ponrov; Keyword(s):

Search: Search took 0.00 seconds; generated 14 minute(s) ago.

  1. I use this program to program the 4l80e this was...

    I use this program to program the 4l80e this was very nice to use , now it shift very smooth " https://forum.efilive.com/showthread.php?5876-Tool-to-help-tune-A4-shift-points"
    Now it`s time to try...
  2. what's pids should be used to log signals in...

    what's pids should be used to log signals in efilive scan tool v7.5
    from Serial Logging with Innovate LC-2, DLG-1, and MTX-D: Ethanol Content % & Fuel Temp.
    My PID "WO2AFR1",...
  3. the reason for 4l80e switching quickly up to 4...

    the reason for 4l80e switching quickly up to 4 gears ,was that the connection C2 16 and 19 on the PCM were grounded.
    so that PCM received signal that 4wd low range was enabled and front axle was...
  4. After testing something more, it turns out that...

    After testing something more, it turns out that after running about 1.5 miles, the gearbox works just fine.
    Tried to just turn off the ignition and then start the engine right after then it works...
  5. Hi Joecar Thanks for feedback. Is there ...

    Hi Joecar
    Thanks for feedback.
    Is there possibility to find a trans. tune(4l80e) that one is sure is right

    Br Ponrov
  6. Thank you for your feedback. Have not studied...

    Thank you for your feedback.
    Have not studied so much yet, but I will compare tune it with tune to as i found online 2002 Chevrolet Express Van Automatic L31 5.7L 4L80e 2wd (12212156) .

    Br Ponrov
  7. PAINLESS PERFORMANCE WIRE HARNESS 1996-99 GM...

    PAINLESS PERFORMANCE WIRE HARNESS 1996-99 GM VORTEC I have modified after Lexhech wire diagram to convert to 0411 ECM and its repin for the 4l80e transmission connector
  8. Hi joecar thanks for the response and you take...

    Hi joecar

    thanks for the response and you take the time to help.

    Engine Pontiac 400 RAM Air lll controll with 0411 ECM
    sensors on Engine.
    76MM Throttle Body from L31 5.7 Vortec
    TPS from L31...
  9. 4l80e change gear completely opposite to what it should

    22800
    Need some advice.
    4l80e change gear completely opposite to what it should at light acceleration gives it instantly up to 4 gears or when kickdown in 3 gears it also goes up to 4 gears ...
  10. Is your tune scaled for MAF or IFR...? I dont...

    Is your tune scaled for MAF or IFR...? I dont know, where can i check it .
    MAF is 75 mm with std GM data
    22571

    The injectors I use is ID850 Injector Dynamics , have used the data from link...
  11. have only had the engine running have not driven...

    have only had the engine running have not driven it, tried on the last log (the picture are from) to switched from CALC.BEN1 to CALC.WO2BEN (same result).

    ...
  12. post someone after work today,

    post someone after work today,
  13. The fuel is 98 octane, without ethanol.

    The fuel is 98 octane, without ethanol.
  14. Both are analogue instruments ,where one is...

    Both are analogue instruments ,where one is connected to LC-2, it shows the same as shown in the dashboard in Scan v7.5 in AFR value.

    That it shows different values in Scan V7.5 CALC.VET map and...
  15. Has now checked the AFR after calibrating LC-2...

    Has now checked the AFR after calibrating LC-2 and mounted Autometer wideband , AFR signal shows the same on both gauge.
  16. Hi Joecar Thank you for your feedback LC-2...

    Hi Joecar

    Thank you for your feedback

    LC-2 is connected with serial connection to V2

    LS1_Link
    ;Main VE Table
    B0101.ROW=SAE.RPM
    B0101.COL=SAE.MAP
  17. How to set up RoadRunner with LC-2 Serial Widband

    Hi I`m new to the forum and new to Efi tuning,are there anyone who has the opportunity to help setup/program V7.5 Scan and tune together with Roadrunner and LC-2 Serial Wideband.
    The firs ting I...
Results 1 to 17 of 17