Does anyone know how to log individual wheel speeds? I have been looking but can't seem to find them. Thanks
Type: Posts; User: Dlong; Keyword(s):
Does anyone know how to log individual wheel speeds? I have been looking but can't seem to find them. Thanks
It looks like you guys are right about what codes to disable. I went back to double check the codes I had disabled and realized I had not disabled p420 or p430. Thanks for the info.
Can anyone tell me which tables to alter to disable the rear o2 sensors? I have added longtube headers and had to use the rear o2's (for the long cable length) and toss the original precat o2's. The...
Sounds like a rod know to me. With a video it is hard to tell but generally a deeper sound is a rod, something more like a tick is generally valvetrain. I would pull the pan and start feeling the...
Thanks TAquickness for your reply. I happened to be at a friends house when he was throwing out some "junk". He was throwing out a gm 3.8 wiring harness. I snagged the iat connector off of it. I...
Thanks for the info Justin. I wasn't able to get the f-body iat but I was able to get a 2000 corvette iat today. Hopefully it will work.
I am adding a methanol injection kit to my supercharged corvette. The IAT is built into the mass air flow on this particular application. Does anyone know how I can move my IAT behind the mass air...
Thanks for the info
Does anyone have a stock tune for an '06 Corvette with the paddle shift? The time it takes to shift from the time you tell it to seems too slow to me. Does EFILive support it yet?
Thanks
I believe the conversion is 6.895 kpa = 1 psi. I'm going off memory but it should be close
It looks like downloading the latest version was the answer. My ifr table (b4001) runs the following numbers in g/sec for 42lb injectors...
The values aren't moving. It will only move a few tenths from idle to wot with 42lb injectors. It seems totally wrong. It is like there is either no real signal or the signal is so filtered it never...
Can anyone help me with the calculated injector flow rate(gm.injflow). I can select the pid and log it but it is obviously not reading correctly. It shows that it is support by my os.:bash:
Thanks...
Thanks for the info. I'll try it.
Can anyone help me locate a thread. I have seen a thread about running a 2bar map sensor without upgrading to a custom os. I can't seem to locate it again. I want to tune the car this way and then...
The only problem I have had is the same as Bruce. When I updated the usb driver with the latest version of efilive the problem went away. I also changed the usb port I was using. So far this is the...
It is a Vortech V-2 SQ that is running 7psi. The car also has a 214-224 114lsa .576 lift cam from comp cams. It also has the comp cams lifters, pushrods, springs and retainers. Just installed an LC-1...
Is anyone willing to send my a copy of their tune. I have an 03 Z06 with a supercharger. I'm not looking for the answer to my issues. I would just like to see some others to get idea if I am on the...
Thanks for the info Andrew.
Any suggestions to elimate a surge at cruise. I have an '03 Z06 A@A Vortech supercharger running 8psi, 214/224 114lsa cam. The car has 42lb injectors and I suspect the injector flow table is...