Search:

Thank you for the reply. Since this last post I double checked everything, pulled radio fuse. Did the full flash test on slow, (on the new ECM bty) it went through the test fine. I decided to give it...

Ross,

Tried everything again several time. No luck. Today I received the new ECM from Killer Bee. Installed it and after the relearn the truck started and ran no problem. I pulled the stock...

Thank you, I will give it another try. I did disconnect the batteries for 24 hours once and tried that.
Sorry i couldn't be more clear about when the full flash stalled. I wasn't paying enough...

Hello all;

Friday after work I decided to install the DSP5 switch I bought from SoCal Diesel about two years ago. I had been putting it off because of all the problems I have read...

I have two questions.

First.

Table B0727, Throttle based injection quantity. It says in the description

Quote
"This table defines the base fuel injection quantity based on throttle...

Yeah, I was wrong. It is working from 0-5 volts. Now it's correct. I must have been smoken crack:) Thank you guys for the help. On a brighter note. I entered a Dyno contest last weekend. I made...

Andy,

I still think that if you use ext.ad1 x 20 will not be accurate.
The sending unit will out put a range of 1-5 volts (if the out put is zero then something has failed) so 1volt would...

I found an error in the Tutorial in their math on the calc_pids.text in my setup anyway. The math they had setup was ({EXT.AD1}*25)-12.5 If the sensor is 1-5 volt and 1=0 and 5=100 this wont work...

YES! thankyou! I fixed the PID from this tutorial and there it said they were using Autometer's 2246 pressure sending unit. Thanx again! Brett~

Hey all, I'm looking for a pressure transducer so I can log fuel pressure using the analog 1-5 volt input on the black box. Has anyone here used the analog input with a pressure sensor? I have been...

Here is one I have been working on. What you think?
2145

Brett~