Search:

Type: Posts; User: andysc3; Keyword(s):

Page 1 of 11 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    42
    Views
    6,674

    What would cause the transmission to shift early...

    What would cause the transmission to shift early on the 1-2 wot shift? I have it set to 6000rpm and 40mph. But its shifting at 5700rpm and 37mph. Have the 2-3 shift set at 6100 and 68i belive but...
  2. Replies
    42
    Views
    6,674

    Seems like the maf was waaay off. Going very...

    Seems like the maf was waaay off. Going very lean at light throttle and the difference between the maf and vve caused the p0101 and the maf to fail. Ended up having to add 20-50% more to the maf...
  3. Replies
    42
    Views
    6,674

    Also, once the p0101 sets it goes back to the vve...

    Also, once the p0101 sets it goes back to the vve and drives like normal
  4. Replies
    42
    Views
    6,674

    Ran I to an issue with the maf tuning. I've...

    Ran I to an issue with the maf tuning. I've reversed what I did to disable the maf. But its sluggish and I'm getting a p0101 when I try to accelerate.
  5. Replies
    42
    Views
    6,674

    I've got the VVE dialed in pretty good. Finally...

    I've got the VVE dialed in pretty good. Finally started working on the MAF tuning. hasn't needed much adjustment. Question on where to have the WOT shift points set to. right now, I have it...
  6. Replies
    42
    Views
    6,674

    Was looking at the min idle airflow and it looked...

    Was looking at the min idle airflow and it looked like it was too high. Avg 10g at idle rpm. Lowered it to 8g and it's idling much better when warmed up.
  7. Replies
    4
    Views
    2,351

    It happened a few times in this log

    It happened a few times in this log
  8. Replies
    42
    Views
    6,674

    i have the maf disabled. It's been well below...

    i have the maf disabled. It's been well below zero here the past week. won't be able to do any more WOT tuning until around late March or April. I am having an issue where it wants to die after...
  9. Replies
    42
    Views
    6,674

    Appears that I'm getting some wheel spin in 1st. ...

    Appears that I'm getting some wheel spin in 1st. it's strange because its AWD but 22s on cold pavement probably isn't helping. I lowered the commanded shift rpm and mph and it helped some. would...
  10. Replies
    42
    Views
    6,674

    Drivability tuning is going well. Got the...

    Drivability tuning is going well. Got the courage up to do a short wot run. 1st gear was a bit strange with it fluctuating. And it reved higher than what I was trying to command the shift at. ...
  11. Replies
    4
    Views
    2,351

    AEM uego randomly shows max lean

    trying to tune my cammed 2011 Escalade. Have a AEM Uego wideband. Never notice anything unusual. but when I look at my logs there are a few places where it goes to 655 and its causing my ben maps...
  12. Replies
    42
    Views
    6,674

    is there a way to better control cold fueling? ...

    is there a way to better control cold fueling? when its 15 or below outside its very hard to start. takes a few tries. then once the engine starts and rpms settle the afrs will start climb to...
  13. Replies
    42
    Views
    6,674

    Update. Tuning has been kinda slow. Only get...

    Update. Tuning has been kinda slow. Only get 1-2 logs a day. Usually on my way to/from work. The ve table under 3k rpm is looking good. But was having issues with the transmission. Was looking...
  14. Replies
    42
    Views
    6,674

    And I have a working wideband now. log showed I...

    And I have a working wideband now. log showed I need to take an additional 20% out of the idle area on the vve table. got timing alittle better, might need to take an additional 1 or 2* out of the...
  15. Replies
    42
    Views
    6,674

    New bosch wbo2 came in. Got it swapped in. Went...

    New bosch wbo2 came in. Got it swapped in. Went to load a new tune with the vve tables lowered in the idle areas but the battery was dead. Seems I forgot to unplug the v2 from the obd2 port along...
  16. Replies
    42
    Views
    6,674

    I renabled stft and after about 30 seconds trims...

    I renabled stft and after about 30 seconds trims went to -25% and the idle started hunting real bad. Guess I'm going to have to wait until the new wb sensor comes in before I can do any more fuel...
  17. Replies
    42
    Views
    6,674

    New exhaust clamps came in. While their not...

    New exhaust clamps came in. While their not fully sealed its alot better than before. Most of the leaks are after the ypipe though. The new o2 sensor for bank 2 also came in. Was orginally...
  18. Replies
    42
    Views
    6,674

    Also thinking my wideband sensor may be bad. ...

    Also thinking my wideband sensor may be bad. With leaving the key on for 30+ seconds then trying to start it. Could have damaged the ceramic inside the sensor.
  19. Replies
    42
    Views
    6,674

    would adjusting C0805/6 cure the P0068? below...

    would adjusting C0805/6 cure the P0068? below 30% throttle the expected change seem kinda low?
  20. Replies
    42
    Views
    6,674

    I do have some slight leaks on the exhaust slip...

    I do have some slight leaks on the exhaust slip connections on the y-pipe. Ordered some better clamps that will be here on Saturday
  21. Replies
    42
    Views
    6,674

    the dtc was set at frame 33000. my efi live...

    the dtc was set at frame 33000. my efi live wouldnt let me load the pid list you attached. there were a few spots where timing dropped to -15. other than that it was pretty good. need to fix some...
  22. Replies
    42
    Views
    6,674

    Okay. So went for a drive. Afr was still pegged...

    Okay. So went for a drive. Afr was still pegged lean. Then got a reduced engine power. P0068 map/maf-throttle position correlation
  23. Replies
    42
    Views
    6,674

    awesome. thank you. Guess its time to take it...

    awesome. thank you. Guess its time to take it off the blocks lol.
  24. Replies
    42
    Views
    6,674

    okay. so next step would be to make sure its...

    okay. so next step would be to make sure its idling, if its good and when it's at temp do an easy test drive and log. then correct spark and fueling as needed? and for the vve map, does it matter...
  25. Replies
    42
    Views
    6,674

    It definitely is. Been driving a buddies car...

    It definitely is. Been driving a buddies car while I worked on it and he is about ready to get it back. I did play around with the dvt idle controls some. Took it down to 700rpm. Any lower the...
Results 1 to 25 of 254
Page 1 of 11 1 2 3 4