How to modify calculated PIds

[Garry]

Garry, post your calc_pids.txt file.

Attached ...

[Ninety8C5]

Somehow I don't get it -- I set up a new calc pid, it shows up in the PID selection, but I can't make it show up in the dashboard ... e.g., I tried my luck with generating a calculated gear estimate, but couldn't even get the basis to show up ... here's an excerpt from calc_pids.txt:

*UNITS
gear None "." "Gear"

*CLC-00-906
gear 0.0 6.0 .0 "{SAE.VSS.mph}/{SAE.RPM}"

CALC.M6GEAR F614 CLC-00-906 "gear" Conditions "M6 gear"

What bugs me is that I get no clue from the scan tool why it doesn't present the PID in the dashboard for selection ... I know I have the VSS and RPM PID present in the logfile and the selected PIDs, as they are used in some other calc pids that are available for display ...

What am I missing here?

I was able to add the M6Gear gauge to the dashboard after I selected it as a supported PID. I think you had the units in the Calc_Pid file in the wrong place. I don't know if that had anything to do with it, but I moved it to what I think is the correct location (about 2-3 lines down from where it was).

[2002_z28_six_speed]

all mine show up fine